Creality Upgrade 3D Printer Kit with Capricorn Premium XS Bowden Tubing 1M， PTFE Teflon Tube Cutter, Pneumatic Fittings and MK8 Socks and Extra Nozzles for Ender 3/3 Pro/5/Voxelab Aquila

Like a lot of people, I bought a used 3d printer for cheap ($100) because i wasnt sure this would be a hobby I got into, and I like to tinker. And like a lot of people who have done this, i discovered there were bits and bobs I either needed to replace/repair, or it was a good idea to replace just to rule them out as an issue. This kit gave me a bunch of that stuff all in one go. Some high quality tubing, a cutter, a couple nozzles, some silicone booties, and some end caps thingies (whatever you call them, lol). Good stuff, and i think the nozzles replacement was wise, because prints look better already (no telling how much use and what materials got run through the old nozzles). happy camper

While removing the Pneumatic Fitting the end broke off and is now stuck inside my printer.

I had to put my old tube back on. This tube will not hold the pressure of the material and will pop out. When it pops out no material is delivered to the print head. I should of took a picture. Sorry

Install was easy, it gave me one good print…..then clogged up with a vengeance every attempted use afterward. Looking into a refund cause the tube that my printer came with is infinitely better

no esta mal pero no vale la pena comprarlo si no se adapta a tu impresora

The tube looked great, but the 1.75mm filament would not push through it easily. The white Teflon tube was nice and lubricated but the Capricorn tubing would constantly clog. I think it is because the tube is not a consistent size all the way through. Therefor it was hard for the extruder motor to push filament through the tube. The reason for the two stars, is the other stuff that came with the tubing were great and I am still using them.

Really improves the printer

The original fittings on Ender 3 that hold the Bowden tube in place stopped holding it. The tube would pop out of the holder after a couple of minutes of printing. I got this upgrade mostly to replace this fitting, and at first I just used the new fitting without changing the Bowden tube. It solved the problem, and eventually I got around to replacing both fittings and the tube. It was easy. I cant say for sure if the new tube makes my prints finish any faster, but the new tube is smoother and more flexible than the original, and the fittings are definitely a big improvement.

This tube cutter is so great to have. Wish I would have bought one earlier.

I was having trouble with my bowden tube during long prints. The heat would get to it and it would become brittle and sometimes even crack right at the hot end. This caused issues. Not a full-blown clogged hot end, but filament would become clogged at the end of the tube. This caused a 2 day print to almost be ruined, which is when I decided to buy the capricorn tubing, as it has a higher heat tolerance. So far, its working like a champ with no issues.