Polycarbonate Clear Plastic Sheet 12 X 18 X 0.0625 (1/16) Exact, EasyRuler Film, Shatter Resistant, Easier to Cut, Bend, Mold Than Plexiglass. VEX Robot, Hobby, DIY, Industrial. Glass Replacement
-
The_trademarks
Greater than one weekThis works great for custom cut fish tank lids. I used an xacto knife like another reviewer recommended. I then snapped it on the edge of a table. For the smaller sections I scored and snapped the pieces using pliers. I needed lids for 2.5 gallon tanks and this was beyond worth it. I got a Command knob to use as a handle and it looks great!
-
JOSEPH BERTRANI
Greater than one weekI used this for a DYI project material is flexible and strong good quality im happy
-
Julie
> 3 dayThis is totally fine and is probably supposed to be like it is. It came with protective coating you peel off. However, I was looking for something bendable. It does say bendable but it only slightly bends. I needed something that actually bends in half.
-
Kathy S.
> 3 daySo far I havent any dislikes. I use the pens on a sheet of Polycarbonate plastic. I place the plastic sheet over a crochet pattern which I use sticky dots to hold the pattern onto the plastic sheet, I then use the markers to mark the spot on the plastic where I left off on the pattern. No problem to pick up where I left off on my project and it keeps my paper pattern clean and neat.
-
Beverly D. Flores
> 3 dayGreat for my project. Easy to cut. 5 STARS
-
Bruce Gintoft
> 3 dayI used this piece to form a border for my iRobot sweeper near my patio doors. Easy to cut and easy to glue to the edge of my patio door rails. This allowed me to be able to open and close the doors without interference AND prevent my iRobot from getting stuck in those same rails. I was able to cut several 3 borders.
-
ME
> 3 dayGood
-
M. Hillmann
> 3 dayI bought this for my cats litter box because he is unable to urinate downwards. Set this up against the wall and it deflects back into the litter box perfectly! No more pee pads taped to the wall :)
-
Marty....
> 3 dayA base for my Parking lot, Marty....
-
Aleksandr Strovanovich
> 3 dayPerfect thickness for modding an Xbox or PS. Easy enough to score and break to shape, just be slow and patient with the process. Dont use acetone or isopropanol to clean (unless you do the ol acetone vapor polish), polycarbonate doesnt like those chemicals too much. I was lucky not to mess up my already cut piece because I accidentally used methanol with a low amount of iso in it to clean before installing.
