Sulky 8.5x11 stabilizer, 8.5 x 11 12-Pack, White

Opens up a world of options in embroidery! Super fast delivery too!

I used this product to embroider on quilt blocks! I traced the pattern using a light board, water soluble pen and pencil onto the Sulky sheet. I also copied the pattern, and used my printer with a Sulky sheet. Make sure you have enough ink in your printer. The adhesive sticks good, does not leave any residue on fabric, even after the material soaks off. You will get some residue on your needle while stitching. I kept an alcohol pad handy to wipe off the residue as needed. I will be using and ordering again as needed.

This product is fantastic

Easy to print on and wash off. Also stays in place throughout the embroidery work I do. I love the ease of this product- running a small hand embroidery business I need as much help as I can get from the products I use! I tried this out once and fell in love, now I plan to keep it on hand all the time.

I was able to embroider with great detail and was very happy about that. It’s is much harder to pass a needle through this stuff so the act of hand sewing was not as enjoyable as it usually is.

It works! I printed a detailed embroidery design, did the needlework by hand, and then washed the backing away. I had been tracing my designs with a lightbox before this. These work wonderfully better - I can print in color and follow my design more easily. You do have to be able to wash your fabric, however - just in warm water, by hand or washer, whatever your fabric can manage. But its good to be aware of that in case you are doing a design on special fabric you dont want to get wet. I use muslin and felt for my designs, so it works a treat! No residue. I love it!

Fue mejor de lo que esperaba, es un buen producto y mis bordados no se vieron afectados por el adhesivo

I bought this to do hand embroidery on lightweight sweaters and knit gloves, and its a miracle product! Eliminated the need for a hoop (which just stretches a sweater out in weird ways and is impossible to work with) and washed away SO easily in a tub of hot-warm water. I did a test run on a sweater without this and I ended up with lines not nearly as clean + used 3x the amount of floss. Does exactly what it says it will!

It prints perfect with a laser printer, adheres easily, and removes without a problem with warm water. I soak it in warm water a couple minutes, and it floats right off. Running it under a warm tap quickly rinses all of it off then. One thing I found: if your pattern is printed close to the edge of the Sulky, it can lift when pushing a needle through. The solution: leave a border! It makes it a tiny bit harder to push a needle through, but not by much.

Same great product as Kimberbell and half the price!