TEMO 10 pc Carbon Steel 3/4 Inch Flat Wire Brush #428 1/8 Inch Shank for Dremel and Other Rotary Tools

I purchased these to use with a dremel to clean carbon build up off of a set of aluminum cylinderheads for a v8. While I was able to clean most of the carbon off of them, the wheels fall apart quickly, even at low speeds and pressure. They fail at the center of the wheel where the wires are held to the pressed metal. They simply fly out of the disk if you push a bit to hard. The same wheels from dremel last tremendously longer and actually break the wires. I wont be purchasing them again.

Used in a small dill press to remove rust from screw heads, safety glasses and dust mask. They held up fairly well before the bristles wore off. Good find.

these are decent quality brushes. they wear out after a bit, which is why I bought this 10 pack, but any fine wire brush will wear out if you really put it to work.

These brushes are ok. Had to put on safety glasses very shortly after starting a project due to wires coming apart and flying everywhere.

I reload my own ammunition. I use these brushes in my Dremel to clean the primer pockets in my brass cases. Because the bristles are nylon, they do not wear away the pockets, and they do a fine job of cleaning.

Better quality than I expected based on other reviews. They work fine and arrived promptly. I plan to purchase from this dealer again.

Shoots little wires everywhere. Life expectancy is about a minute per wheel. Used all ten down to the nub and didnt even make a dent in my project. Safety glasses are a must and cleaning up a billion little wire arrows took forever. The hundred or so that stuck in my shirt and hair were an added bonus.

They dont last very long, maybe 10 minutes of use each before the wires are down to nothing. Wish I could compare to real Dremel products but theyre too expensive.

the worst Ive ever used. stay far away from these. they are a waste of money, trust me.

Worked as well as some name-brand brushes Ive used, and far less expensive.