Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

(0 reviews)

Price
$15.99

Quantity
(10000 available )

Total Price
Share
73 Ratings
22
10
8
8
25
Reviews
  • MO

    > 24 hour

    Horrible and dangerous piece of junk steel. Do not use. Bit was cutting MDF when it yielded.

  • roger

    > 24 hour

    Both bits were out of balance on first use. I double checked with my other bits and everything on router is fine. Piece of junk . Be careful with these.

  • style design law

    > 24 hour

    This is a brilliant idea, since it is generally the bearing that goes on these flush cut bits. I bought this, fired up the router, went a couple inches on the cut, and the screw and bearing flew off. Alright, maybe it doesnt come tight enough to use from the factory. I retrieved the pieces, put it back together, tightened it, but the same thing happened. I repeated this process, tightening the screw until the allen key skipped in the screw head. It is thus not possible to tighten the screw any tighter with the allen key. Well, the screw and bearing once again flew off after a few inches. This time I reassembled, tightened to the max with the allen key, then tightened further with my vise grips. The screw snapped off, rendering that bit unusable. Moved to the second bit, tightened to the max with the allen key until it skipped in the screw head, then gave just another 1/8 turn with the vise grips. Perfect! Fired up the router, cut a few inches, the screw and bearing flew off again. So I conclude: brilliant idea, but unfortunately does not work.

  • Jason

    > 24 hour

    Cheap product, didn’t last more than 5 minutes each. Save your $ buy Freud.

  • Ryan

    > 24 hour

    Pretty trash. The bits aren’t sharp enough to make a dint in 40k minis. The handle does what it should, so I just got some higher quality bits from Bunnings.

  • Simon Gick

    > 24 hour

    Using this to drill holes in 3D prints for M2 and M3 screws. Sturdy little tool for precise work. Would recommend.

  • Amp Pope

    > 24 hour

    Good value

  • Steve

    > 24 hour

    Great value but dont use freehand routing it needs both bearings in contact with the work surface

  • Jeanette McBeath

    > 24 hour

    Abolutely thrilled with this hand drill, didnt expect it to arrive as soon as it did, super fast delivery which was great as I urgently needed it. Works like it says and was very pleased

  • Angel

    > 24 hour

    Como se ven en la imajen , buen material y precisos.

Related products

Shop
( 1187 reviews )
Top Selling Products