YEEMIGO 2 Inch Caster Wheels Metric Size M8×25mm Threaded Stem Casters Castors Wheels, 360 Degree Direction Double Brakes Industrial Wheel Furniture Caster for Carts and DIY Tools Pack of 4

These are exactly what I’ve been looking for! Perfect fit for my IKEA table with ALDIS legs. Twist off the adjustable height part from the original leg, and twist these new casters in. These casters are very well made, they can roll all directions and each of them can be locked! They’re actually making the desk more stable than before! This final desk height is 31.25” comparing to old 29”. Be aware. But it actually feels very comfortable height for my computers!

Good size, just what I needed to lift a mobile TV cart so the legs could roll over the extensions of an existing table. Well made, easy to install.

Pay a little more and get these.

Used this for a cart. Load ( including cart) never exceeded 200 lbs. Cart was moved about 5 feet every week. Bearings are now loose and the wheels are wobbly on their stems.

I bought these to put on my new Uplift desk. They were a bit smaller than I had envisioned, but they are doing their intended job. Came with a flat wrench but it was a little fiddly getting them on. Once on though, they have stayed put and I can now move this behemoth of a desk around my carpeted floor when I need to.

These wheels dont mess around. If you need to slide silently across your hardwood floor without making a sound or a scratch, or if you need to lock up those wheels to make sure you dont slide backwards as you type 320wpm...you need YEEMIGO.

Regular PC and the wheels are folding and wont spin

It works very well, however I did not try to lock it. I install it to my small air compressor which weights about 30 Lbs and I cannot lift it anymore.

These are decent quality casters at a very good value. I bought them because of the included long threaded inserts, which are helpful for adding casters to old wood feet. I used an 11.5 mm brad point drill for the threaded inserts and an 8 mm Allen wrench to screw them in. The inserts were a tight fit, so I threaded a couple turns, then backed it off, then a couple more, then backed off, etc. like you would use a tap for threading. It made a solid, snug fit - perfect for the casters. After installing the casters, they rolled very smoothly and worked well. These arent the most solid casters Ive bought, but they were the right small size that I needed, and a good value - a low cost solution for my needs. Someone asked and then deleted the question, but the casters raise the feet 2.5 inches above their original height. Recommended!

Works well!