Zoofen Replacement Luggage Wheel Repair Suitcase Bag Parts Spinner Wheels Casters for Travel Customs Box W044 (A SET 4PCS)

They took a long time to arrive but so far, they’re great. The screws were too short so we used the original ones (not a big deal). They roll smoothly! I like my suitcase so it’s nice not to have to get a new one just bc it had two bad wheels.

These fit my Samsonite bag perfectly, but they just didn’t hold up when placed into use. Literally, the first time I checked this bag, one of the studs holding the wheel to the bag snapped. See photos. This is too bad because it was a lot of work to install these and now I’m going to have to start over…. If I could reach the seller (can’t) I’d ask them to send me another set so I could see if this failure was just bad luck or is typical.

Wherls look good. They were hard to install. You have to use force to match the insid and juggle around with the part that goes on the inside to get them just right to install the screw

fit and look like the original wheels

Gran calidad de producto

I used this kit to replace the 4 spinner casters on my 26” Samsonite. I had to wiggle the casters a bit to get them to fit in, but they were very close. The only “trick” was which screw to put in/tighten first. I didn’t have to cut anything. Way cheaper than a new case. Recommended.

The wheels were for my large Coleman suitcase which stopped rolling smoothly after one trip. These replacement wheels are generic and may fit your suitcase perfectly or need some fitting (enlarging/shifting holes to match the screw bosses for the new wheels) like it did for mine. After some sweat and fitting and re-fitting, the wheels are working well and handled a 60lb overloaded suitcase with no problems. Time will tell if they will last.

These wheels were mis-represented as a replacement for the Delsey suitcase. They were to large and did not work.

They are as close as exact replacement that you are going to find for this big Samsonite bag. The backing plates that come with it are a bit thicker than the original and made installation a pain. I reused one of the original backing plates from Samsonite because I got tired of fighting with the one that was included. I reused the original screws because they were longer and they needed to be to reach through the bag to grab the wheel. Installation took longer than it should have but thats life. The bag swivels like a brand new suitcase. Money well spent.

Installation was difficult and the wrong length screws were sent. The screws also required washers to hold and not pull through the plastic and fabric of my luggage. The wheels only wanted to roll in one direction, not Omni directional like most luggage wheels. Lasted two trips before I was frustrated enough to by new luggage, not a good experience.