4 Doors Complete TCP/IP RFID Access Control Systems with North American Standard Electric Strike for Latch Doors Keypad Reader 110V Power Supply Box Phone APP Remote Open Door

Long user review without an incentive… We purchased and installed 2x 4-Door Controllers to currently operate 7 (of 8 possible) doors. I did all the wiring and programming myself and only needed some assistance from other employees when initially pulling wires from doors to main controller. So far I’ve found that these do everything that our old EXPENSIVE ($7200+ monthly fees) Kantech controllers did, (in our previous building), but with more control and NO MONTHLY MONITORING FEES. The new system uses the same Low Frequency RFID, just without the proprietary accessories and coding. You can see by the pictures that we used way too many wires that were a bit bigger then was necessary, but that was 100% our fault. We had the ability to do just basic configuration, up to automatically setting doors to unlock after a certain user swipe and remain unlocked for the day, or lock again after entry. MANY 3rd party accessories work with this system, but they also carry everything you need. We went way beyond basic as I started realizing it’s all in the basic programming to unlock all the included options (free). We even installed an emergency lockout buttons so if someone shouldnt have access or is a threat before disabling their access, we can hit button (from anywhere) and lockout all doors instantly from being utilize. Push button again and it’s all back to normal. The only gong aditional you’ll need is a small 12-7ah backup battery or Backup UPS to plug into (both optional) in case of power failure, AND wiring to all your doors/sensors. Wiring of this size is very inexpensive and can be purchased in a box of 1000-ft. of either alarm wire or CAT-5 (Ethernet wire). This system can be used with additional RFID rings, key cards, bracelets, keychains, or even stickers from this seller or 3rd party. We did have a few questions on programming, and a quick email was answered within minutes. Instructions for Every feature you want is available online, and there is a corresponding video. The fact that the whole thing is a 12V system, makes it safe to install on your own, with no worries of doing something wrong. You can always have someone install it for you, but we have a drop ceiling, making pulling all the wires pretty simple, so much so, we over did it a bit. NOTE- PRE LABEL YOUR WIRES AS YOU PULL THEM for ease of connecting. You can even use colored tape to mark each set of wires to correspod to the proper doors/accessories. For example: Yellow = main entry door card/pin reader Yellow & Red tape = entry door exit button. Yellow & Blue tape = entry door exit IR sensor. Green= Storage room card/pin reader Green & Red = Storage room exit button. Green & Blue tape = Storage Room Exit IR Sensor ETC. Each wire bundle has its own wires inside it (typically 4-wires in each), or you can use CAT-5 (or cat6/cat7 etc.), which will give you 8 wires in each. We did end up using CAT-6 on the last door after realizing our initial wires were bulkier than necessary. Made it a LOT easier, as long as you noted which individual wire color hooked up to it corresponding accessories. Pretty easy with some forethought. I can’t say enough good things about support and they always answer immediately! We used a LOT of features, and about every available option on each door, including readers, PIN#’s, IT exit sensor & exit buttons. Also utilizing rfid (finger) rings, badges, key rings, and phone app. Certain doors are programmed to stay unlocked during business hours, while others need a swipe or PIN# continuously. Setup options are endless, but again, you can also just do basic setup and scan each time you enter. Did I say support is incredible? They are!! They’ll send you direct links to AMYTHKNG you’re trying to accomplish, and just when you think something isn’t working properly, they’ll let you know exactly what you did wrong without even sending a picture. We had one door that would read incorrectly, and they knew right away that we didn’t have a specific colored wire (grey) connected properly. Support is forever, free, and you can’t ask to many questions. They’ll even jump on a video call if you want, or help you set it up remotely if you’d prefer. ANYONE who leaves a negative review just isn’t trying or has no patience. If you want a secure system that does everything, you’re going to have to install it no matter what you buy. So if you have basic knowledge of how to follow direction and tighten little colored wires into wire ports with a tiny flat head screw driver, look no further. Once you program the controller with all your users and features you want, it’s also self contained and DOES NOT need to be hooked to network. Only need to plug into network for initial programming or if you need/want to make changes to the control board (also if you want emote access, but really not necessary). I did not receive or get promos made anything for this review, I just see the occasional negative ones and it’s obviously an issue with patience or expecting a secure system to somehow come pre-wired to your facility (impossible). Ask for HELP, and it couldn’t be simpler! Many Thanks to XIANGYUN and BRs/Wood Chen for the detailed assistance, the whole system has work flawlessly with your excellent support and videos. The couple initial (minor) issues we had were all due to us mislabeling, or not wiring something securely. Plus, we brought way too many wired into the box which caused self-inflicted confusion atone or two. It’s actually so much simpler than it’s made out to be if you pay attention. If there was anything I would change, it would be having a complete user manual with every option available in front of you. I understand why they don’t do this, as it would likely get confusing for those looking for a basic system and the manual would get overwhelming to a new user if they didn’t realize most of it is just optional programming and/or accessories.

Ive had to email for different questions, I get instant replies, get this on weekends; -very technical help, very thorough; -I ran into troubles understand permissions, lock install, and lots of other questions Ive had; -A nice to have: An unrelated question about how to integrate relays (not supported, but they did anyway); -this is a top notch group, very willing to help, with every single email it says we support you forever (not something Im all that familiar with, how cool is that?); -I work in IT, they always say sorry, not us, call such and such, or worse its in the manual - these guys give you a plethora of YouTube links for every question. I was up and running inside of 45 minutes, the app took me 30 mins to figure out, but pretty straight forward once I got all his links (theyve got lots and lots and lots of links). If theres a con, Id say there isnt an install video on how to physically install the strike (they had one, but for the one exception it wasnt quite what I needed). However, I found a number of lock installers DYI YouTube videos, so not an issue. I really like this company, they stand apart from so many. -Theyre a winner outfit, a winner group of people, something youre really lucky to find in todays day and age. How nice. -Id recommend this company to to a family member, a friend, or a stranger. ==Five Stars===

Well made and easy to install and customer support is A+++++++

I ordered the 4 card reader panel with strikes. The install was very easy and the provided instructions helped answer any questions during the install and setup process. Full Disclosure: I am very handy with a technical background which made this install go very well. However, experience isn’t needed if you can follow instructions and have the right tools. The customer support was very responsive and helpful. I emailed a few times to answer some questions (error on my part during install), and they always answered within a day (time difference). I highly recommend this product.

Exactly what I needed to expand an existing system. Customer support was very helpful in making everything work together. Will be buying more as we expand the card access system across the building.

This is so easy to install and program. Tech supports are fast and clear. Good products

I was skeptical at first just because I’ve never done door access controls. Follow all the instructions by clicking on each link the supplier supplied with the order. The program used to allow access and record of who and what time that privileged employee accessed which door. First setup is really only 3 steps to get it working. The usb reader card is very easy to setup an access card or keychain. Worked perfect using a Ubiquity switch I use for my camera system. Recommend to anyone. Like the supplier states it is a great value.

I installed 3 controllers handling 12 doors along with Fire Department module to open all doors when fire alarm

System works perfectly. Tech support is the best I have experienced. Quick to answer and always has a ez manual or directions to follow.

First you should know: there are NO PAPER MANUALS. Everything is in online documents and pdfs. its all pretty easy to follow and reference once you can find all of the pdfs you need. The wiring diagrams are very self explanatory, and easy to follow. The software manual is also easy to follow, but you will need to google around some to find one of the passwords, or ask the support team. But you’ve got to navigate around a few web pages to gather all the available pdfs to get everything together. The technical support was incredibly helpful! They were able to provide me with all of the resources I need, and were very quick to do so. They provided pdfs, links, tips and videos within a few hours of me reaching out. I even had a super obscure and specific question (the support rep who responded said I was the first person to ask for this in many many years) but was able to provide everything I was looking for. Last heads up- you will need to get extra cable to run from the controller to each of your doors. Not for the faint of heart, and it’s no smart lock that you can easily swap out in 10 minutes. You’ll need to dedicate some time and a no kidding afternoon or two to get everything set up and working. But it is absolutely worth it, and the support team is there the whole way.