5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

I got a replacement thermistor wire from Creality tech support and their’s was about 5 inches too short. This wire was the same length as the original. It got my printer up and running again and I have a few extra for the future.

Easy replacement, works as it should. Been reading temps accurately up to 270C in my use case.

2 out of 5 worked. The right length for an ender 3 pro fit perfectly just 3 didnt work longer then a minute. they fit with cable to spare on an ender 3 pro, customer service was great when i contacted them about half of my order not working then refunded me my money and sent me 3 new ones to replace the ones that where bad at no cost. 5 star customer service all day. would buy again just for the customer service help.

as advertised

I had to cut and wire this to my cr-10 but a few youtube videos i was confident to do so.

Bought these for my Voxelab Aquila. First one I tried to install was a bit odd and cracked the bulb. Second one installed just fine. So far it has been working good.

This item was as described. It also seems to be working properly

They fit and function as described.

I was having trouble with runaways until I bought these for my 3D printer. Problem solved, and Ive got several backups just in case!

I used this to replace the thermistor on my Neptune 3 and it seems to be working great. A lot of people say the cables arent long enough. I did not see if it was long enough. I just cut my old thermistor wires and soldered this one on. In my opinion that is far easier than running the cable back to the board. Works as advertised with spares so 5 stars from me.