5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Fixed what ailed my Ender 3

Installed this on my v2, no adjustment necessary, worked out-of-the-box! Would recommend these and would purchase again.

The quality appeared very good. I spliced the wiring rather than thread it all the way to the board. Solder joints and heat shrink. The temp fluctuates +- 4C wildly. I suspect the glass bead is a bit loose fitting. Heat paste may remedy this.

as advertised

This has 2 major flaws for use with CR-10S Pro V2. 1. The cable is WAY too long. I was able to hide the excess in my printer, but man is there a lot of it. 2. The connector is the wrong connecter for CR-10S Pro V2. It is able to physically fit into the connector on the board, but it is not the correct type of connector and does not have locking mechanism that is supposed to be on the connector. I suspect it is possible for it to fall out after extended use. Im giving this 2 stars because it does seem to be at least doing its job and what it supposed to do, despite its flaws.

No issues, just follow any random youtube video on how to install a Thermistor and it was cake.

When upgrading your 3d printer it is a good idea to have replacements on hand

Thermisters worked perfectly and are of good quality. Very pleased with my purchase and its nice to have spares for when I need to replace them. Very good buy.

Ok , be prepared o cut wires and solder The connector fits no Creality machine. Will it work , I dont know.

My only complaint is that the wires need to be about 6 inches longer. They worked on my Voxelab Aquila, I just had to be creative with how the wires are positioned in the shroud. My fan wires are now sticking out so the thermistor wires are unimpeded.