5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Work perfectly, but VERY fragile. Be careful installing

My only complaint is that the wires need to be about 6 inches longer. They worked on my Voxelab Aquila, I just had to be creative with how the wires are positioned in the shroud. My fan wires are now sticking out so the thermistor wires are unimpeded.

I got a replacement thermistor wire from Creality tech support and their’s was about 5 inches too short. This wire was the same length as the original. It got my printer up and running again and I have a few extra for the future.

A lot of sexual innuendos.. but here it goes! I bought these for my Ender 3 pro due to thermal runaway and I probably should have tested it first but the tip of these thermistors don’t fit in the hole on my hotend. They’re too big, holes too small.. I don’t know, however I did see a lot of comments about length and it being too short, I didn’t have that issue, just doesn’t fit. Rendering my printer useless once again

Upgraded the machine and the extra length on these was super helpful. Did just what its supposed to.

got the parts two days later, got my printer back up and running. not as good as a cartridge thermistor, but is used on two of my printers so worth the money so that i dont have to upgrade them.

Works great on monoprice printer.

I have an ender 3 and was having temperature issues causing the system to shut down and make a very loud tone noise. I was having thermal runaway and it was a safety feature that shut the system down. The hotter and temperature probe was the issue and this product cured my issue.

These work for me on my ender 3 pro. After printing a temperature tower with new filament I get similar results as I did with my old thermistor when I did temperature towers with a different, new roll of the same filament before. Im not an expert but if i cant tell the difference and I needed a new thermistor anyways, this fit my needs. If you are installing these, watch a few videos. It can be VERY easy to break these, and it is not the manufacturers fault.

Others said the length was too short. I had no issues with that on my Ender 3. Working great so far, and it’s been a few weeks.