5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

They fit and function as described.

Great replacement for stock ender 3, matches then length of the original

This is the correct replacement part for an Ender 3 printer thermistor. It just wasnt what was causing the problem. That was a fault on the driver board.

These are easily damaged and can ruin an otherwise good day of printing, should it fail. Got these for the parts bin. Peace of mind for me.

Ok , be prepared o cut wires and solder The connector fits no Creality machine. Will it work , I dont know.

The wire is crazy long, but i had to rewire it anyways. The white plug was to big for my neptune, so i took off the teeny clamps and cover off the old wire, cut the new one to length, and inserted it into the old white plug. So it was a bit of work to adjust that part of the wire to fit, but its working fine. Ive looked elsewhere online for thermistor wires for the neptune 3 pro/elegoo, but could find any or wasnt sure if they were the right one.

This has 2 major flaws for use with CR-10S Pro V2. 1. The cable is WAY too long. I was able to hide the excess in my printer, but man is there a lot of it. 2. The connector is the wrong connecter for CR-10S Pro V2. It is able to physically fit into the connector on the board, but it is not the correct type of connector and does not have locking mechanism that is supposed to be on the connector. I suspect it is possible for it to fall out after extended use. Im giving this 2 stars because it does seem to be at least doing its job and what it supposed to do, despite its flaws.

I have an ender 3 and was having temperature issues causing the system to shut down and make a very loud tone noise. I was having thermal runaway and it was a safety feature that shut the system down. The hotter and temperature probe was the issue and this product cured my issue.

These thermistors are too big to fit into the hole on the heat block that comes with the Ender 3 v2. Thats an awful thing to discover right at the end of the installation. The thermistor that came out of my Ender 3 v2 is 1.94mm. These are all greater than 1.97mm and none of them fit into the hole on the heat block.

Not good for ender 3 max to short