5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Worked perfectly to replace the thermistor on the Ender 3 V2. I spliced it in and soldered it.

I used this to replace the thermistor on my Neptune 3 and it seems to be working great. A lot of people say the cables arent long enough. I did not see if it was long enough. I just cut my old thermistor wires and soldered this one on. In my opinion that is far easier than running the cable back to the board. Works as advertised with spares so 5 stars from me.

Drop in replacement for Ender 3 Pro.

The wire is crazy long, but i had to rewire it anyways. The white plug was to big for my neptune, so i took off the teeny clamps and cover off the old wire, cut the new one to length, and inserted it into the old white plug. So it was a bit of work to adjust that part of the wire to fit, but its working fine. Ive looked elsewhere online for thermistor wires for the neptune 3 pro/elegoo, but could find any or wasnt sure if they were the right one.

Fixed my thermal runaway problem.

This is the correct replacement part for an Ender 3 printer thermistor. It just wasnt what was causing the problem. That was a fault on the driver board.

Exactly as described.

Product works but the clip is incorrect for CR-10 V3. There is an extra piece of plastic on the side that does not allow the clip to connect. A simple snip of the plastic solved it.

I am now on my third thermistor from this pack . Each has worked for a few days then I get a thermal overload error . After that I get it on every print and have to change it out again . Poor quality product .

Purchased a brand new Ender 5 plus and the temperature sensor read -15C or 355C max temp. Super happy a cheap solution by replacing the thermistor solved the problem.