900095 Padding Felt Adhesive White 1/4 Thick 6x2.5yd Orthopedic Rl Part# 900095 by Aetna Felt Corporation Qty of 1 Roll

Works great on my calluses 1/4 is perfect since it will compress Leave a void of about 3/8 and lasts all day and night. My patch is about 1 x3

I used the product to build up arch supports given by my podiatrist.

This tape helped line my boot along the shin when I had a fractured foot bone. It was the only product I could find and it is enough for a neighborhood full of clutzes. In other words I only had to use a little bit of it but I really couldnt have done without it. I still have lots left so will try to pass it on to someone else who can use it.

Reasonably priced. Perfect thickness for Morton Toe support. Cuts to size easily - an inch at a time. Will probably last me a couple of years. Sent in zip lock bag, so the roll stays clean & doesnt swarm. Peeling off the paper backing isnt easy. The adhesive is very sticky, which makes it adhere to skin just fine. Taping on with paper tape also works.

I wasnt able to use a lot of the product because it wouldnt peel.

I ordered this due to a metatarsal foot injury. A podiatrist had created a padded wrap with a small section cut out to take pressure off of the sore area. While this helped, trying to put a shoe on with a padded wrap is horrible..it constantly slides around. This felt roll was the answer to my problem. I traced my shoe insert and cut out the small section as the doctor did. Because there is no issue with this sliding in my shoe, I am not using the adhesive. I did try to peel the backing off to test it out because people commented on the difficulty. Once you can separate it correctly, it peels easily. But it is difficult to find the correct way to peel it...its easier to accidentally peel the whole piece off incorrectly. Take your time and keep your patience and youll get it. And for those who say there is no adhesive, either they got a defective roll or it was peeled incorrectly. The adhesive is quite sticky, by the way.

Havent start to use this yet but I will, I wanted this to make insert for shoes that are too hard..

Just what I needed, fast shipping

Almost impossible to remove from the backing.

I havent used them yet but I plan to cut out arch supports for low arches in most of my shoes. They look to be the right thickness.