ANTCLABS BLTouch : Auto Bed Leveling Sensor/to be a Premium 3D Printer (with 2M Extension Cable Set)

I ordered my BLTouch through 3DMaker World after an order mishap from another vendor on amazon. Before receiving my BLTouch I had a BLTouch clone that was completely unreliable even on 3mm glass. The first picture is the measurements from the BLTouch clone, and the second is from the genuine BLTouch. I am using aluminum spacers to help with my warped bed. I will be double checking my spacers with calipers to make sure theyre the same length, and I just received a replacement bed from the manufacturer. I already had a pin27 board, and a version of the firmware ready to flash. The wires were easy enough to run through the cable sheath up towards the hot end. I will be in the market for another bed leveling device, and Ill most definitely be paying for another genuine BLTouch, and I already know who Ill be ordering from. Thank you AntClabs for the amazing product, and thank you 3D Maker World for supplying a new version of the BLTouch. I couldnt be happier with the purchase.

Works great on a ender 3 v2

I installed this following the instructions for CR-10S Pro V2 and using the firmware by InsanityAutomation for 10SProV2. Works great.

I had issues with the wiring not having the correct pins but I just made it fit with other pins, thought it still did not feel firmly attached to the board. 2 stars for the wires included since the connector is useless, 5 starts for the BLtouch itself.

No problems at all, after installing it on my skr 1.4 turbo. Seems to give perfect leveling with a 25point mesh on my cr10 s5.

The quality is good but the documentation is not.

I received this and installed on my Ender 3. It would not work and I tried many things including changing some parameters in Marlin but still didn’t work. I then eliminated the 2 wire lead (black and white wire) and connected directly to board and it worked. Turns out the 2 wire lead is bad and there is probably a break within the insulation.

Included connectors? Useless. Documentation? What documentation. What a massive waste of time and money. Going back to leveling myself this is obnoxious.

Love that it does work on a cr10s pro you just need to add the jumper cap that comes with the bltouch for the version 3.0 they have pictures on there web sight

Bought this to replace the sensor that came stock with my CR10s pro. it came bent. I didnt try to straighten it but it does seem to be working