Anycubic Upgraded ABS-Like 3D Printer Resin, Hardness and Toughness 405nm UV-Curing 8K Resin, High Precision and Easy to Post-Process Standard Photopolymer Resin for LCD DLP 3D Printing (Grey, 1kg)

Ive been getting some really good results with this resin without having to do any troubleshooting. My models are coming out clean with streamlined edges and smooth finish, with the toughness that comes with using ABS like resins. This resin has been easy to use with both of my printers, and doesnt require any special parameters during post or for curing. In terms of odor, its barely noticeable which is a plus. SETTINGS: * Printer = Mars 2 Mono, Halot One Plus * Layer = 0.05mm * Bottom layers = 10 * Bottom exp time = 50s * Layer exp time = 4s * Lift delay = 4s * Cure time = 15min * Wash time = 25min Superb resin that provides consistent and reliable results.

Ive been using the Anycubic ABS-like to do some bigger prints that I wanted to make sure werent brittle and would be a little more sturdy (think props for costumes). Its working really well so far. I have had to adjust my settings a little bit from my regular resin, but a little trial and error with something new isnt unexpected. On my Mars 3 pro, Im doing some heavier prints, so I increased exposure on bottom layers and on all other layers by a bit, also using beefier supports--parts of my test print stuck to the FEP, so wanted to avoid that. Later prints with updated settings have been working well.

This is without a doubt the worst resin I’ve ever used. Fails nearly every time and separates within about 1 hour of mixing. Will never purchase again.

Printed with the recommended settings: 50 seconds first layer, 2.5 seconds per layer after that. For larger and heavier models, other resins I use want longer bottom layer exposure times for several layers. This resin wants you to use a raft. I dont really print large models, usually just 2-3 tall, so I hollow them out and usually leave a large portion of the bottom open, then plug it after curing. Totally satisfied with the resin. The odor is typical.

It’s much nicer than regular resin but still pretty brittle for my purposes.

warping verzehrungen die nicht durch den drucker oder deren einstellungen kommen finger weg!!!!

I havent printed a lot other than chess pieces for my sons chess club at school with this. But so far the pieces have held up well to grade school age kids using them and knocking them off the table. The cure time on the finished pieces took longer than what I am used to with other resins which I am having a hard time figuring out. I have had to add about 10 minutes to my cure times. The longer cure times arent really a big deal to me, it just surprised me.

Ça simprime mais pour le reste cest très décevant. Aucune résistance comme lABS comme il peut y avoir chez dautres fabricants. ça casse pratiquement comme de la résine classique. Cest de la résine + ! le plus ça doit être parce que cest beaucoup plus cher… autant rester sur de la résine de base.

Quality resin that works perfectly on my Photon Mono X. I appreciate the other brands, but it just works when you buy resin made for your Anycubic printer. I used some of the community profiles on LycheeSlicer, and this resin was spot on. There is no chalky skin after curing, and the prints look amazing. This is a must-buy at least once for anyone with an Anycubic Resin Printer.

My first time using ABS like resin and it makes me like my Elgoo printer even more! Look for a comparable resin chart for your model and also double check the color of the resin as well because sometimes that affects the settings. As this was white resin it had slightly different settings than clear or black.