Authentic Creality Assembled Hotend Kit for Ender 3 / Ender 3 Pro/Ender 3 V2 with Capricorn PTFE and Upgraded Pneumatic Fittings, Thermistor, Heating Element, MK8 Sock and 4 Extra Nozzles

This kit the heater connection comes with 2 ended wires with no connector on it. When you state that your part is a direct replacement, it should come ready to plug in, not in a state where I am going to have to redo the connectors to get them to work. I would not buy this again because of that.

One to one replacement. East to install.

This was just like the one on my ENDER 3 when it was new except this one is Aluminum color instead of anodized red. I see springs in the last picture, but it is not listed as part of the kit. I didnt receive the springs. The swap was easy. You may want to update you pictures.

If you need spare parts this is the kit to get. Shocked to see actual capricorn and not the other stuff marked capricorn.

great replacement and easy to switch out

The hotend works great, and all the extra accessories were as expected and work great as well. But the hotend received was not the red and brass one shown in the picture, it is an all silver one. Not sure if its an off brand, or they switched the look, but wasnt too pleased to see it look completely different. Keeping it installed since it works great though.

My bad -- the product info warned of the voltage difference. The CR is 12 volts, this unit is 24 volts. I had to salvage the 12 volt thermistor and heating cartridge from an old unit to modify this unit.

its hot 4 sure

Works well

FSt and fits correctly.