Authentic Creality Assembled Hotend Kit for Ender 3 / Ender 3 Pro/Ender 3 V2 with Capricorn PTFE and Upgraded Pneumatic Fittings, Thermistor, Heating Element, MK8 Sock and 4 Extra Nozzles

Needed at least a thermistor and decided to just get the whole works. Worked great and ended up having to use parts off of the old one on another machine. Easy replacement that works as the stock unit does.

Works well

It works and its the same as the original. Worst part about it is this review has a star rating for warmth. Not sure what thats about. Its a hotend not a warmend.

Everything was good quality installed easily without issues

It was a lot simpler to install than I thought. No need for sodering like I dearer, its as simple as unscrewing panels and pluging in. I unfortunately cut the sleeve to get to the wires, but you dont have to do that. You can just unplug the wires and slip the sleeve on and off

The wire leads are not plug and play. You will need to use electrical tape or some heat shrink to reconnect your old terminals. Plus the filament tubes are way too short (long enough for direct drive I guess). Update. Wired in the hot end and the thermostat on it is busted and reads -14 on my machine. Tested it against another hot end and it reads normal. Final assessment, this was a bad buy. 0 stars if I could rate that.

Capricorn tube is way too short.

replaced my defective hotend/thermistor/heating element printer was back up and running in a few minutes easy swap

This was exactly the same as the original hotend. Perfect for my 3 v2 ender! I cant believe it included Capricorn tubing! This company is great for upgrades!

Ive been using this replacement hotend for a few days now and its working much better than the original. However im not sure how much of this is due to the Capricorn because this is my first time using it. It sure seems slippy compared to my old bowden tubing. These upgraded fittings are definitely an improvement on the ones that came stock with my ender 5 too.