Authentic Creality Assembled Hotend Kit for Ender 3 / Ender 3 Pro/Ender 3 V2 with Capricorn PTFE and Upgraded Pneumatic Fittings, Thermistor, Heating Element, MK8 Sock and 4 Extra Nozzles
-
ken
Greater than one weekFSt and fits correctly.
-
Gabby
> 3 dayEverything was good quality installed easily without issues
-
Todd.D
> 3 daySuper easy to install all the parts were already assembled. This came with the capricorn tubing and as an awesome value for money! After installing the new hot end The printer was back up and running and print quality was smooth and consistent just like before! Great replacement!
-
Dr. Bridgette Rodriguez
> 3 dayThis is an OEM hot-end for an Ender 3 or 5 (and others) along with a Capricorn bowden tube and some handy extra parts. My Ender 5 pro started under-extruding after a couple of months. This swap was a little involved the first time. The power leads arent terminated, which feels cheap at first, but they need to be bare so they will fit through the webbing (Ah Ha!). Once those leads (and the thermal leads) are through the webbing, cut off the end of your old hot-ends power wires (leave an inch or more). Slip some heat-shrink over the power leads, then solder the old plug to the new wires. Either ways fine; no polarity. And like me, you just replaced a failed part with the same part. Still, a good deal for all the bits you get, and my is back up!
