Authentic Creality Assembled Hotend Kit for Ender 3 / Ender 3 Pro/Ender 3 V2 with Capricorn PTFE and Upgraded Pneumatic Fittings, Thermistor, Heating Element, MK8 Sock and 4 Extra Nozzles

It works and its the same as the original. Worst part about it is this review has a star rating for warmth. Not sure what thats about. Its a hotend not a warmend.

My only issue is that the wiring doesnt come pre-terminated. When you use pretty specific terminations it kind of makes sense to fit the replacement parts the same way so that they are plug and play.

This was my first time having to replace my Hotend and it worked as advertised.

So, it was a little daunting to disassemble my printer in order to replace the hotend with this kit. I was afraid I would not be able to figure it out, but honestly, it made perfect sense as I replaced it. The real test was clicking the print button and seeing my Ender 3 print again for the first time in months. There are no instructions but there are tools and if you have some common sense - you will be fine and happy you ordered.

If you need spare parts this is the kit to get. Shocked to see actual capricorn and not the other stuff marked capricorn.

What comes with the the item is exactly what is in the description

This was just like the one on my ENDER 3 when it was new except this one is Aluminum color instead of anodized red. I see springs in the last picture, but it is not listed as part of the kit. I didnt receive the springs. The swap was easy. You may want to update you pictures.

I ended up getting rid of my printer and contacted the seller about returning this, and they were amazing at getting things taken care of for me. Good customer service strongly like the product but didn’t want to use it because I didn’t need it yet.

The pict shows the nice blue tube connected and everything ready to go. That is not actually what you receive in the package. You get a white tube connected and you get the fun of trying to putt it out and put in the new one. There are so many scratches and bends form using pliers and tools to get things in place the whole thing looks like crap. Waste of time and money. If they wanted to sell a kit why didnt they say kit? This thing is destroyed before the first print and I get stuck with the bill. Horrible.

The wire leads are not plug and play. You will need to use electrical tape or some heat shrink to reconnect your old terminals. Plus the filament tubes are way too short (long enough for direct drive I guess). Update. Wired in the hot end and the thermostat on it is busted and reads -14 on my machine. Tested it against another hot end and it reads normal. Final assessment, this was a bad buy. 0 stars if I could rate that.