BIGTREETECH Direct TFT35 V3.0.1 Touch Screen with Two Working Modes Smart Controller Panel Compatible with Graphic LCD 12864 & Touch Menu WiFi for SKR V1.4 Turbo Manta M4P/M5P Ender-3 3D Printer

I have no dislikes. The TFT70 is awsome works great and super easy for my failing eyesight.

like a lot of amateur 3d printers out there, I really struggled to get this display to work. I purchased the BTT skr2 control board with this display. I have little to no experience configuring and installing firmware. thank god for youtube. I could not get the touch part of the display to communicate my printer, constantly saying no printer found. I checked and rechecked my baud rates, my ports, trying every freaking combination. updated the firmware on the display. nothing seemed to work. even contemplated ordering another display as failure was not an option. In the firmware Im running what it turned out to be was I did not pay close enough attention to the pin out of the skr2 board. once again common sense was of little to no use to me. on the pin out pdf i had downloaded, it says tft next to the pins on the board, and by the way the ribbon connector that comes with the display is shaped, just a plain female slip on connector, i assumed that it went with the pins on the left of the TFT writing on the board and not the connector on the right of the writing as those pins actually take a clip into locking style connector, forgive me I do not know what the technical name is for them. This would of been a lot easy to figure out if Big Tree Tech had either provided the right connector or designed the SKR2 better, In my opinion anyway. my firmware settings are, Baud rate: 115200, serial port: 1 I did not use serial_port_2 I left it disabled. you should be able to up the baud rate to 250000 but I have not tried yet. I hope this helps someone out as it would of defiantly help me.

The touch screen function is great. Unfortunately, it does not work in Marlin Mode. The screen is completely blank when marlin mode is activated. I will have to send back. There is absolutely no technical support available.

Does my 3d printer NEED a larger screen than my phone? No. But I am a man. And as such, I have big Man Hands. When I tryed to get all handsy with the little 2.4 it was a less then fullfilling experience. This 5 however, works great. I can easily manipulate all the buttons, and it works in both touch screen and Marlin mode, so thats nice. Would have gone woth the 7 model, but I felt intimidated.

Pretty much plug and play, just grab your firmware from the github repository. I will be a loyal BTT product consumer.

I received the product damaged, when I tried to use it, it would overheat. I tried to reach out to the company and they were very rude. I would not recommend purchasing this item.

Great upgrade for the Ender 3 Pro with the SKR 3 board.

Part of an upgrade I did to my 3D Printer, Excellent change from the stock screen and dimmable. It lets me run the printer for days long prints without having to worry about the screen lighting the room up at night. Love the ability to switch between touch screen and 12864 modes. Onboard SD and USB drive ports to print from.

Hands down was one of the best upgrades I made to my ender 3 v2 only because it made the motherboard I bought along with it so much more usable with the touch user interface.

I am just getting around to hooking this screen to my 3D printer build and it does not work, it doesnt recognize the printer and Ive spent hours troubleshooting. I cannot get any assistance from Bigtreetech and now Im told that I cant return the item. Will never buy again.