Comgrow Textured/Smooth Double Sided PEI Sheet 235mmx235mm for Creality Ender 3/Ender 3 Pro/Ender 3 V2/Ender 3 S1/Ender 3 S1 Pro/Ender 3 Neo/Ender 3 V2 Neo/Voxelab Aquila 3D Printer

About to buy 3 more for spares.

Great replacement bed for my enders.

This works great for my Ender 3 Pro with Bl Touch. I tossed aside the magnetic bed sticker that came with it. The magnet already on the bed was stronger. Prints come off cleanly and unlike my Prusas PEI steel sheet, it doesnt seem to leave a mark when i remove a print! Skip the fuss with glass and the stock rubbery bed. Get this bed and get printing!

If you can suffer through the trial and error of getting the right temps and bed leveling the results are great and consistent time after time afterwards. Ive found that having my bed temperature at an intense temperature (relatively speaking) of 80 C it begins to stick, PLA and PETG seem to stick to the bed at this temp. If I hadnt known this fact I would probably thought this was defective because literally nothing would stick before that.

Well the first print I did with abs stuck pretty good but ended up warping a little off the build plate im used to that then tried some Amazon pla never used that brand before but I also have never had such a hard time getting pla to stick to the build plate it was very frustrating and I am not used to seeing pla warp up off the heat bed either I clean the pei 3x with 91% before I started and I have a bltouch adjusted the probe z height and still nothing good to report! I think Ill switch back to my glass bed

Started out great, but appears to have a hard time releasing smaller and thinner parts. Printed several larger pieces with petg that released nicely, but then printed a smaller, long piece as a replacement part for a project, the thicker part came off, but where it got thin wouldnt release and ended up taking a small chunk out of the coating when it finally released.

My first print on it and its destroyed... so disappointing...

Fantastico. Nulla da dire. Lunica pecca è come è stato applicato ladesivo in PEI...qualche bollicina e pelucchi di polvere

I was having some issues with the glass bed that came with my Ender 3 which turns out to be because the coatings worn from the sheer amount of printing I do on this machine, so I decided to try going with one of these PEI coated flexible print beds... the difference between my clapped out glass bed and this is impressive. Once I got it dialled in with my 1.0mm nozzle (I do a lot of large prints), Ive not had any peeling or adhesion issues at all so far. Im gonna keep playing with other materials like PETG, ABS and the reel of TPU that I have and see how these turn out but so far, Im very happy with the results Im getting just on PLA.

so supposingly this is the next best thing from a glass bed... unfortunatly i didnt have much luck with this.. gutted thoe cuz it was much better than the standard magnetic bed... i stuck with glass in the end