COMOWARE Hole Saw Kit for Wood- 16 Pieces 3/4’’-5’’ Full Set in Case with 1pcs Hex Key, 2pcs Mandrels and 1pcs Install Plate for PVC Board Plastic Plate Drilling Drywall and Soft Wood

I used this to saw a hole in particle board for a piece of furniture where I needed to run wires through it and it did the job perfectly. Comes with a variety of sizes and easy to understand instructions. Youll need a power drill to use it, but if youve got one this comes with everything you need (bits and all) to secure it in place and cut a clean-looking hole. Definitely recommend for anyone whos handy or just needs to cut a hold in a particular piece of furniture (get this! dont just take scissors to the back of your TV stand, trust me!)

I have only used these on 1/4 inch and 3/4 inch plywood so far and am not super impressed. The little plate that secures the hole saw bit is thin; any pressure make the outside edges of the bit flare out and gave me more “coned” hole. The top of my hole was the correct dimension, but as I progressed, the bottom was an 1/8 inch wider. And that was 1/4 inch plywood. When I used it on 3/4 inch Baltic birch plywood….the difference was an entire 3/16 of an inch. I was using this on my drill press at about 1,000 rpm. And yes, my drill press is aligned and tuned to perfection. These hole saws are worth the money but not the frustration.

I probably did not screw the attachment well enough…. After making the hole, it separated from the drill and fell inside the wall… now it is lost. I was using it for the first time. Attach it very tightly!

Used this to go through asphalt shingles in the roof to put in a vent. If I had more than a couple to do, there would have been a problem as the tool was chewed up. For softer plywood, the quality would be fine.

I was working with a pine board and the saw struggled to cut the hole. Great price, but only for use on very soft materials.

They are cheap and won’t hardly go thru wood

The hole saws worked well but it looked like it arrived used. Also had some sort of oil on it. Got the job done on making holes on acrylic. It wasnt as smooth as I want it to be though. Ill keep for now, not gonna return a used product to be sold again used.

worked for what I needed to do. A possible adjustment might be to have some holes in the back of the flat plate to allow the cut out piece to be removed from the saw easier

Decent product for the price if you are just an occasional DIY person. If you are the type that would use these on a regular basis, this kit is not for you. It took 20 seconds to cut a 4” hole in 1/4” cedar panel.

I needed a hole saw to make corn hole tables and this one was very inexpensive than most. It was a little difficult to put together, but it worked.