Corsair 5000D Airflow Tempered Glass Mid-Tower ATX PC Case - Black

The modular components are nice. Makes building in this case ez. Some notes though, the dimensions (width in particular) for the side mount radiator needs to be paid close attention to. EK coolstream 360 fit with no issues but when I swapped to a hardware labs GTS 360, I had to widen the holes on the mounting bracket because the rad is a few mm too wide and the holes on the rad are misaligned. Also, should be noted that to put a push/pull rad with fans in the top mount, the pull fans need to mounted on the outside of the case (though they are still hidden beneath the pop-off metal panel).I had to offset my top mounted radiator slightly using some brackets because the crosshair viii mobo I used did not have enough clearance for rad + fans (25mm) without crushing the CPU 8+4 ports in the top left corner of the case. All in all though I would buy this case again. It’s reasonably priced. The design (save for a few minor clearance issues) is well thought out and the materials used in the case feel premium.

The guy delivering it knocked on my door and seeing Im a woman, suggested I get help carrying it up the porch stairs. I told him I got it and he shrugged and walked away. Ive built six PCs. I know how heavy a computer case is.

Must be good, no complaints from grandson. Built his own computer.

I just built two PCs using the 5000D Airflow case, both of which were using parts I had previously used in a Thermaltake Level 20. The Thermaltake is a midtower with two 200mm front fans I replaced with Noctua units. The two insides are an i9-9900K and 2080 Super, and an 11900K with a 3080 Ti.

I bought this to transfer components from a micro case that was not ventilating well (5-7 degrees C higher than normal even at idle. Part of the set up uses Corsair RGB fans for ventilation, and a 360MM Corsair RGB AIO for cooling along with 3 ICUE controllers fan and RGB for the ventilation fans and one controller for the AIO controlling fans and RGB.

I bought this case because I had the meshify C but its too small especially for the 3080. I had zero space to mount a front radiator and this card next to eachother but in the 5000D theres like 3 inches between them now. Theres tons of space inside of this case and the materials are all top notch. Only downside is its going to be heavier than a mid tower, obviously because its bigger, but other than that no regrets buying it because my PC looks amazing now and I dont have to work with 5mm clearance.

My setup has never looked better. All these upgrades made a bigger case a nessecity. The cable management is so nice. Everything is wrapped together and makes even the backside of the case look good. GET THIS CASE

The thumb screws come out the factory screwed down so tight you wouldnt think theyre called THUMB screws.

Easy to build in and great for a ton of cooling. I have 9 noctua 3000rpm fans in this case with awesome airflow. I love the design and it is very easy to build in. Wire organization is also great and the straps make it even better for securing all of your psu wiring. One thing is if you plan on keeping the HDD tray it is a pain in the a$$ to use the secondary cover for the side fans. If you plan on keeping the original shroud on the side it will work great. Would recommend!

Absolutely love this case. Has all you need and all the space you’ll need. Room for a ton of fans for great cooling. Highly recommend!!