Creality Ender 3 Glass Bed Upgraded Platform 235x235x4mm for Ender 3 S1/ Ender 3 / Ender 3 Pro/Ender 3 V2/ Ender 5/ Ender 5 Pro, 3D Printer Tempered Glass Build Plate Surface

The original magnetic base was easily damaged at ABS print temps. The glass replacement has no problems.

if only it were flexible. good adhesion (be careful with PETG as you need a sacrificial layer). This was way thick and I needed to adjust my z stop for my Ender 3 pro. Might want to add a layer of foil between the glass and the factory magnet in case they bond too well. Much better surface than factory glass.

Good quality.

This bed isnt quite the same quality as my original Ender 3 V2 bed. I had this bed for about a week and on my 8th or 9th print a piece of the glass bed just came off in the center of the bottom of my print. Its not just a part of the top black printing, an actual piece of the glass came off. You can feel the divot in the glass. This wasnt caused by any tool or anything and you can see it is in the middle of the print where nothing would come in contact anyway. Before this the bed seemed fine and I had no complaints but now Im wondering if this glass bed just had an imperfection that made this happen or if this is something common.

No matter what i do, nothing sticks to the surface. I do not recommend this product! Get the flexible metal plate instead from annother seller.

I purchased this as an upgrade to my base Ender 3. It was very easy to install. I just used binder clips to hold it on. A couple of tips for those new to printing like myself: Make sure to move your z-axis switch as it will make bed leveling much easier and prevent you from scratching yours like I did to mine. Also, print your first layer with a hotter bed and hot end temperature. Ive been doing PLA prints and I am doing 70*F bed and 205*F end to make sure the print does not warp. I anticipate the coating to wear out over time but you can flip it and use the smooth glass side with adhesion like a glue stick or hairspray. Overall, much better than the stock bed.

I bought this to use on my Ender 3 because the original (fiberglass?) build plate was significantly warped. My first print on this glass build plate didnt adhere, so I cleaned it thoroughly with isopropyl alcohol and also raised the bed temperature from 50 °C to 55 °C. That did the trick, and Ive done multiple prints that have turned out perfectly. So far its been very easy to remove the parts from the plate (much easier than the original plate): basically, they snap right off when the print is done. I only print using PLA, so I cant vouch for how it would work with other materials. One issue to note is that you will need larger binder clips, since this plate is much thicker than the stock one.

works great

This is my 3rd glass bed as I am slowly replacing all of my magnetic ones. I hear a lot of complaints about the bed not fitting printers but you must raise the z-limit switch to provide the necessary clearance for the obviously thicker bed. It’s a quick and convenient upgrade IMO providing the biggest bang for the buck in performance.

Works and fits great on my Ender 5 Pro! No need for anything to hold it in place no clips no nothing it just stays in place. Also all of my prints stick to this bed fabolously without any glue or anything, would definatly recomend this product.