Creality Ender 3 Glass Bed Upgraded Platform 235x235x4mm for Ender 3 S1/ Ender 3 / Ender 3 Pro/Ender 3 V2/ Ender 5/ Ender 5 Pro, 3D Printer Tempered Glass Build Plate Surface

I really wanted this to work. I even bought a thickness gauge to ensure proper height of the nozzle and everything was perfectly level. The failure lies with poor adhesion. I now need to see if print bed glue will help.

I very happy with bed glass adhesive and very easy to remove after print. Compared to magnets sheet that come with ender. I used dial indicator run across to check flatness within .002 after heated

Worked great when I got it. After about a month, PLA does not adhere well at all anymore. Printing at higher heat and lower first layer helps, but there is always curling now, and smaller prints always fail. Better to find something that wont wear out quite as quickly

Ive had difficulties with this plate, but it can easily be my fault. Ive tried increasing the temp and using alcohol to clean it, but Ive still had adhesion problems. But I would still recommend giving it a try, its easy to install and worth giving a try since most people have success. It does hold heat well since its glass, but you may need to heat it up longer than usual at the beginning. I will probably give it another try if my original plate fails again.

Good quality.

This bed isnt quite the same quality as my original Ender 3 V2 bed. I had this bed for about a week and on my 8th or 9th print a piece of the glass bed just came off in the center of the bottom of my print. Its not just a part of the top black printing, an actual piece of the glass came off. You can feel the divot in the glass. This wasnt caused by any tool or anything and you can see it is in the middle of the print where nothing would come in contact anyway. Before this the bed seemed fine and I had no complaints but now Im wondering if this glass bed just had an imperfection that made this happen or if this is something common.

I’ve been getting PERFECT first layers using this print bed. HIGHLY recommend! And I recommend using 65 degree Celsius for printing, DO NOT remove your print from the bed until it cools down to 35 degrees.

DO NOT BUY FROM THIS SELLER!!! We were charged twice, once from Amazon and once from the maker. We are reporting this to Amazon so the seller AnKun hopefully will be black listed. The 3d printer itself is marginal at best. The floor warps, hence the reason we were buying a glass bed.

Had problems with adhesion but everything else seems great. May need to mess with heat. Thicker bed may mean I need to increase bed heat

I was a little worried about ordering a piece of glass like this off of Amazon, but it was well packaged and works great! Pretty sure my bed is slightly warped because I havent been able to level it properly or get a good print since I got the printer, but this definitely took care of my issues