ELEGOO Mercury Plus 2 in 1 3D Printing Wash and Cure Station V2 for Mars Photon S Photon Mono LCD SLA DLP 3D Printer Models

I am very satisfied with this wash and cure station. The only thing I dont like is that it defaults to the curing setting (it would make more sense for it to default to wash, since that is done first). I consider that pretty minor.

I ran about a liter of material prints through this unit and the power supply died (external power brick). Sent a few messages to the elegoo support and not a word (its been two weeks). I decided to run this unit on my bench power supply to see if maybe the unit caused the supply to fail with like a short or something since I am going to have to buy a new external power supply. So once I set it up and ran it I found when the unit is running the light cycle with the UV lights it draws 4 to 4.5 amps. Since the power supply that came with it is only a 4 amp supply no wonder it failed. So I bought a 5amp external supply. Ill post another review if it eats this one two. Other then the power supply it works well, I have moved to using monocure3d resinaway instead of IPA and have had the best results out of any cleaning system I have used to date. Unfortunately 2 stars is all I can give for a unit that hasnt been fully tested before shipping. Update its now jan 7 still no response. Pretty sure they do not care about customers at this point.

Makes cleaning resin prints easier.

Unboxed the wash station to discover that the attachment fir the build plate was missing. The main reason why I bought the wash station was to wash the build plate. Cant do that without the attachment. So disappointed!

Bought this to handle the prints off of my Elegoo Saturn (I mostly print minis) and this thing is a life saver. I wash with 99% IPA and then warm water to remove supports. After it dries I use the curing mode and havent had any problems during my few months of this process! Definitely recommend this, looking forward to a Saturn sized one though!

I thought I had a good system for cleaning and curing resin prints, but this machine really does make it easier and better. Having things centralized is convenient, and I make less of a mess. The wash tank is very convenient, and the curing light does a better job of curing than my old UV light.

Funny story, got this thinking it was the printer to find it was the wash/curing machine. After getting the resin printer low and behold I needed it and was so happy to have it!! It cleans the prints perfectly and the curing process makes them much more durable and saved alot of prints that wouldve been flimsy otherwise. Super glad I got this first cause I wouldve had no clue I needed it!!

The curing part of this product is absolutely fine. But the washing part does absolutely nothing. Even left a print in for 10 mins and when it came out, it was still completely shiny as if it did nothing. Don’t buy this for washing ad it does not do that whatsoever

Ive had the Mercury+ for about 2 weeks now. I turn it off after each wash/cure session and so far have only used it 3 times. It now no longer powers on (the power cable shows that it is receiving power though). This is an issue Ive had with the Elegoo MARS in the past and I believe will probably be fixed the same way. The power switch isnt the sturdiest thing and can apparently burn out just from sitting there plugged in. By replacing the power switch with a similar one (rocker switch, usually for boats) it will hopefully get back to working just fine.

So, this is just like the AnyCubic wash and cure station... just slightly bigger, and just enough. Large prints depending on how large. Most prints do fit. All the features are exactly what you need to wash your prints and cure them. Headache free.