Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

Nicely made clips but unfortunately the ender 5 table with a glass plate and a PEI sheet is too thick for it. by about 1mm or so.

They dont work on my Ender 5 pro

works as expected. hasnt let me down.

The surface coating is not even and way too rough (close to #30 sand paper).

These clips were the perfect match for my replacement tempered glass print bed. They are low profile, easy to attach, easy to remove, and they firmly affix the glass to the plate. Even after tons of prints and vigorous scrubbing they havent moved a bit. Definitely a must have.

I bought these because I thought they would be an upgrade t my office clips. For me these clips were way to tight. I have an Ender 3 Pro with a 4mm Creality glass bed, but I noticed when leveling that my glass bed bowed slightly in the middle when these were used. I went back to the office clips and the bed was flat again.

While the clips are intended to hold a glass top tight, I found I could barely fit the first clip and the second to tight to get on. Given the glass will grow with heat, I wonder if if it wouldnt even crack the glass itself. Nice, small, good finish but to tight for my application.

Bought these for an Ender 5 Pro with the glass bed upgrade. I did not remove the magnetic sticker below the original print bed. Had to strech these out to fit, scratched the glass. You will need to remove that magnetic layer first! This is probably mentioned in other reviews that I did not see. No instructions or anything so dont throw caution to the wind like me!

Worked perfectly with my glass bed, as mentioned the magnetic surface has to be removed.

Way better than the garbage stock springs. The silicone spacers are better yet. Bed stays level for much longer. The medal knobs feel very substantial as compared to the plastic ones that are stock.