Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

Scratched glass bed and didnt hold . Waste of money.

I level my glass-plate bed manually, each corner and the center always varied a little, so it was always a compromise. The Ender 3 V2 only comes with two clips, so I thought Why not 4? I wish I had done this sooner... Leveling is easier, first layer is more consistent, the process is just easier all around. Yep. Upgrade your springs... Level your bed... But now Im adding Use FOUR clips!!!

Way better than binder clips. Nozzle never runs into these. Might grab a few more because I switch build plates while I wait for my 3D prints to cool

i oread it 3 month agow and hasent turend up

Ordered these to compliment the two that came with my Ender 3 v2. They look identical and fit perfectly. These are paired with the glass plate, so probably would not work with thinner mediums. It holds the plate in place, what more could you want.

Worked perfect for the ender 3

Actually easy to put on and remove unlike other clips, I actually only use 2 cause they work so well

While the clips are intended to hold a glass top tight, I found I could barely fit the first clip and the second to tight to get on. Given the glass will grow with heat, I wonder if if it wouldnt even crack the glass itself. Nice, small, good finish but to tight for my application.

I use them on my glass bed. It looks more professional than binder clips. They hold well and are easy to pop on and off.

Always have these around and are much better than the binder clips that come stock with most printers