Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

Worked perfectly for my Ender 3 Pro with Creality gland bed and looks very professional. Sure, I could have used the binder clips like most, but I wanted something with less bulk and a sleeker look. - Helpful Tip - 1. Youll need to remove the adhesive magnet layer from your hot bed. Start by peeling up a corner and slowly work toward the center. Without any heat (machine off) I was able to carefully unstick the entire layer as one piece while ensuring I didnt put too much pressure on the machine. 2. Place your glass bed on the bare metal plate and slide your clips into position (see my attached photo). - Would highly recommend this to others.

Not much to say other than they do exactly what theyre supposwd to do. No more bulky binder clips!

While the clips are intended to hold a glass top tight, I found I could barely fit the first clip and the second to tight to get on. Given the glass will grow with heat, I wonder if if it wouldnt even crack the glass itself. Nice, small, good finish but to tight for my application.

works as expected. hasnt let me down.

Works like its supposed to!

The surface coating is not even and way too rough (close to #30 sand paper).

Way better than the black binder clip

These chips worked perfect on one of the creality Ender 3 machine I bought with the Ender Logo on the glass bed with the dragon, but I bought another set and they are too tight to fit on that glass bed I notice it says creality on that bed both bought from resellers, and the other bed says Ender with the dragon logo, both beds are creality but one it just a little bigger.

They work as expected

These are a great set of clips for the Ender 3 Pro. You do have to take off the magnetic bed liner for them to fit. They also get quite hot when you heat the bed, only something to watch for when leveling the bed.