Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

I bought these because I thought they would be an upgrade t my office clips. For me these clips were way to tight. I have an Ender 3 Pro with a 4mm Creality glass bed, but I noticed when leveling that my glass bed bowed slightly in the middle when these were used. I went back to the office clips and the bed was flat again.

Way better than binder clips. Nozzle never runs into these. Might grab a few more because I switch build plates while I wait for my 3D prints to cool

These are a perfect fit just as the originals that came with my printer.

Pros: Heavy Duty Red Wheels; Silicon Spacers; Holding great using only M420 S1 for abl. Cons: Was a bit of a pain to level, but doable. These work great so far. Been on a printer that I just built. Took a while to get the bed level, even with using bed leveling visualizer from octoprint; But now it is set and forget. I probes the bed a few times manually after each print for a few prints and it remained the same. Been printing 8+ hours a day for a week with M420 S1 gcode in place of G29 (load mesh vs creating a mesh every run) with 0 problems. Love it.

I used those small paper clip things and always hated them. These hold the bed down better and they dont stick out at all. Its a good upgrade if you want to spend the $10. But these should be more like $5 for 4.

Many have complained about having to remove the magnetic base on the build plate to make these clips fit. Removing the material is simple. Preheat the bed to 45c and then using a razor score the top of the material into roughly 1.5-2 strips and then use your scraper tool to lift the corners it is easy to remove the strips.

Small enough to go under my printers print head holds great. I have a lotamax v2 with glass bed

These clips were exactly what I needed to secure my glass bed

Holds glass down well

1 of the 4 fit loosely so I threw it out, I only use 2 so I have a spare