Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

They work as expected

They do as the manufacturer intended. No issues with them what so ever.

Many have complained about having to remove the magnetic base on the build plate to make these clips fit. Removing the material is simple. Preheat the bed to 45c and then using a razor score the top of the material into roughly 1.5-2 strips and then use your scraper tool to lift the corners it is easy to remove the strips.

Bought these for an Ender 5 Pro with the glass bed upgrade. I did not remove the magnetic sticker below the original print bed. Had to strech these out to fit, scratched the glass. You will need to remove that magnetic layer first! This is probably mentioned in other reviews that I did not see. No instructions or anything so dont throw caution to the wind like me!

Scratched glass bed and didnt hold . Waste of money.

i oread it 3 month agow and hasent turend up

Always have these around and are much better than the binder clips that come stock with most printers

They dont work on my Ender 5 pro

Exact same clips that come stock with Creality printers that include glass beds. 1000x better than binder clips.

Worked perfectly for my Ender 3 Pro with Creality gland bed and looks very professional. Sure, I could have used the binder clips like most, but I wanted something with less bulk and a sleeker look. - Helpful Tip - 1. Youll need to remove the adhesive magnet layer from your hot bed. Start by peeling up a corner and slowly work toward the center. Without any heat (machine off) I was able to carefully unstick the entire layer as one piece while ensuring I didnt put too much pressure on the machine. 2. Place your glass bed on the bare metal plate and slide your clips into position (see my attached photo). - Would highly recommend this to others.