Tool Daily Pressure Washer Sandblasting Kit, Wet Sand Blaster Attachment, 5000 PSI, 1/4 Inch Quick Disconnect

(0 Reviews)

Price
$28.99

Quantity
(10000 available )

Total Price
Share
97 Ratings
47
21
12
8
9
Reviews
  • justin

    > 3 day

    Had a issue with it sucking up the walnut shells,had to keep taking it out and moving it around

  • Eric OTeney

    > 3 day

    So far so good

  • broncos denver

    Greater than one week

    This thing is awesome. Was worried about the price to get my pool wet blasted as we have gone too many years without deep cleaning and have been very lax with chemical balancing. Combine that with very very hard water and I have a very expensive problem on my hands and this year it was finally to stop battling the calcium and algae. So we drained the pool and I ordered this in hopes of saving some money. Well, this thing is everything I could have dreamed of and more. It is so worth the money. Tonight after work I ran to Home Depot and got 400lbs of silica sand and got to work. It’s reusable, once it’s dried out you can load it all back up and use it again. (Side note, I turned my pressure washer down to a low idle to start and worked up the idle a little bit until it was adequately removing the scale and algae and deposits exercising caution not to damage the walls of the fiberglass pool.) I got about an hour into playing with this thing and then it got dark so I snapped a quick picture of the progress so far. The steps to the left and the white area near the steps are sand blasted. The darker area to the right is freshly pressure washed and resembles the condition the steps were in before sand blasting them. 10/10 would recommend to anyone!

  • Terry Gross

    > 3 day

    We used this attachment on our pressure washer to remove concrete stain off our driveway. We could not remove the stain with the pressure washer only. This product was absolutely amazing!! The only issue was it used so much sand. We are currently on 2400 lbs of sand. I wish we could control the amount of sand being dispensed. I would definitely recommend this!!

  • Russell J.

    > 3 day

    Worked good when new, tips worn after 300 pounds of sand and the wand developed a leak where the tube was joined to the 1/4 quick disconnect.

  • Ofelia Moore

    > 3 day

    great pressure washer tool

  • Prof. Larissa Okuneva

    > 3 day

    Forget about this if you have to clean anything that’s standing upright. The water seeps back into the hose and clog the sand from coming out. If you have a lot of time on your hand to waste, then go ahead and get this. You’ll spend more time unclogging the sand hose and drying it out before you can use it again. It’s getting 1 star from me because it couldn’t do what I wanted it to. I have steel bars standing at 12’ high to get the rust off. Every time I lift it about 5’ high and release the pressure wash nozzle the water runs back into the sand hose. I was going to get a one-way valve installed but I didn’t had the time for that also not sure if that would’ve work either.

tool dailytool daily
Pressure Washer Sandblasting KitPressure Washer Sandblasting Kit

logologo
Tool Daily: The Great Brand for Pressure Washer Accessory

Tool Daily are committed to developing more efficient and safer pressure washer accessory, helping people reducing the tiredness of spraying and cleaning in the garden. We are known for amazing pressure washer accessory, such as nozzle, wand, gun, coupler, foam cannon. We do everything in our power to ensure customer’s full satisfaction with the product quality and service.

SPECIFICATION

Replacment Nozzles are available. Product "Tool Daily Pressure Washer Sandblasting Nozzle, Replacement Wet Sand blaster Attachment, 5000 PSI, 2-Pack".

  • 1. Minimum Flow Rate: 3 GPM
  • 2. Minimum Pressure: 3000 PSI.
  • 3. sand into water system.
  • 4. Max Working Pressure is up to 5000 PSI.
  • 5. 1/4 Inch Quick Connect.
  • 6. Temperature is up to 140°F/60℃.
  • 7. Orifice 3.5.
 Pressure Washer Sandblasting Kit Pressure Washer Sandblasting Kit

Application

Pressure washer sand blaster kit works for abrasive cleaning. Great for removing rust, graffiti, paint, baked on grease.

 Pressure Washer Sandblasting Kit Pressure Washer Sandblasting Kit

How to Set Up

1. Connect 1/4’’ quick connect plug (B) to pressure washer trigger gun or wand.

2. Insert sand wand (C) into media (dry silica sand, baking soda or washed and dried river sand). Please make sure the sand is dry, or it will not work.

3. Turn on the pressure washer. Unlock the trigger gun, then water and sand will come out from permanent nozzle (A). Please make sure the part D is above permanent nozzle (A). If the part D is underneath permanent nozzle (A) as the image shown, the water will go into the hose of sand, wet the sand and then sand will not be sucked up.

4. After work, please dry the cleaned goods as soon as possible, otherwise they will rust again the next day.

Related products

Shop
( 610 Reviews )
Top Selling Products