Tool Daily Pressure Washer Sandblasting Kit, Wet Sand Blaster Attachment, 5000 PSI, 1/4 Inch Quick Disconnect

Down not suck the sand with a 2700psi 2.5 gpm sand.

Sand will stop flowing constant prep needed helper is helpful

Works great. Im using baking soda and a plastic tarp to catch the runoff. After you collect it and dry out the water it is reusable. Seller was quick to respond that spare ceramic inserts (the wear item of the unit) will be available mid Nov. 2019 via amazon!!!! Great service!!

Overall, it works well enough as it does what it is supposed to do. However, the suction hose is not long enough to keep your dry sand out of the way of water spray/ splash from using the blaster. A person could cover the bucket of sand with a plastic bag but then you wouldnt be able to see the sand level and tilt the bucket accordingly. 3 stars I would say, 4 stars if it had a sufficiently longer hose.

For the money it’s fine. It clogs up a lot but that’s an easy fix.

I didnt this would take paint off as easy as it does. My pressure washer is only 3000psi and 2.5 gallons a min, if I had a bigger one it would be faster.

2.5GPM, 2900PSI Pressure Washer with 3.0 nozzle. Blasted an entire car frame that was rusting since 35. Took (17) 50lb bags of media to complete, and around 8 hours of blasting. Used Black Diamond Fine Coal Slag from Tractor Supply. Some very important notes. 1) the supplied hose must be replaced immediately. I blasted half of the frame with it, and the internal ribs and large diameter of tubing cause the media to be pulled through the nozzle in waves. I replaced it with a 3/8 fuel line, and immediately had far better success and consistent blasting. Note that the hard lines accept 1/2 hose. I forced the 3/8 line on, and felt the smaller diameter produced better suction. 2) if you get any water in the hose, swap for another dry hose. I tried blowing the water out with air, and just could not get it completely dry. Kept clogging. 3) this is a very slow and messy process. But for the price it is worth it. 4) metal will flash rust but is easily resolved with a wire wheel.

This attachment easy to use however, the sand is not regulated. The sandblaster attachment works good with a little tweaking.

Works pretty well. Be prepared for a mess. But I used it to blast and clean my 60” mower deck inside and out. Keep your sand dry and this thing will suck it out of the bucket just fine. I recommend

While this is cleaner than regular sandblasting, its not quite as good. I was able to remove some old flaking powder coat of of a wheel and would still recommend this product. No problems with clogging or water getting in the hose. Id have to use it more to give a more in depth review.