Tool Daily Pressure Washer Sandblasting Kit, Wet Sand Blaster Attachment, 5000 PSI, 1/4 Inch Quick Disconnect

Looks great, fast shipping with prime, can’t wait to use it.

Forget about this if you have to clean anything that’s standing upright. The water seeps back into the hose and clog the sand from coming out. If you have a lot of time on your hand to waste, then go ahead and get this. You’ll spend more time unclogging the sand hose and drying it out before you can use it again. It’s getting 1 star from me because it couldn’t do what I wanted it to. I have steel bars standing at 12’ high to get the rust off. Every time I lift it about 5’ high and release the pressure wash nozzle the water runs back into the sand hose. I was going to get a one-way valve installed but I didn’t had the time for that also not sure if that would’ve work either.

works better than I thought it would

Too good to be true?? Yep!!! You cant get a quality sand blaster for $30. I tried but it simply does not work. Product failed from the very firsr use. Could not get it to suck up media. Followed all the instructions exactly.

Tried using the harbor freight 100lb media blaster with an air compressor. That was a fail; whatever you blast will ricochet and blast the crap out of you and get the sand and debris all over everything. Great exfoliation for your arms and everything not covered, but excessive amounts of sand in your butt crack. With this pressure washer attachment everything stays relatively clean and the dust/ sand stays knocked down. I was able to use this with sunglasses, shorts, and a t shirt while getting a better end result. The only thing thats kind of a bummer is whatever metal you blast is going to flash rust. The best rust converter I used was Eastwoods rust encapsulater. Pair these two together and youll be golden.

It is an excellent tool gets the job done

Its works ok. Need a slight modification then it works great

Ill start by stating the obvious; if youre looking to start a sandblasting business out of the back of your truck, this isnt what youre looking for. If youre looking for a great way to sandblast the occasional fender or a now-and-then larger project, this is a great setup. I am using it with a 3.2GPM 3100PSI gas pressure washer, and it flows well, cuts well, and covers a respectable area with a better-than-average rate of sand usage. I was able to clean a rusty flatbed frame in about 15 minutes. The water keeps the dust down (you still get sand everywhere).

Works great but wore through suction hose rather quickly. Easy fix.

Worked very well but the hose needs to be longer.