5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

Bought these for my Voxelab Aquila. First one I tried to install was a bit odd and cracked the bulb. Second one installed just fine. So far it has been working good.

Measured against a good thermistor from an ender 3 pro which read around 99K using an RLC meter out of circuit. These were measuring around 114K. That is 14% tolerance not the specified 1%.

They have worked perfectly, it went well for the cost and I liked the organization as they came to me, it was quickly to assemble and start printing.

Work great and easy to fit.

My original Ender 3 Thermistor failed after 3 years. This one is exactly the same as the original, wire length, wire type, connector to motherboard, and functionality. I prefer this one over the one that has you splice the wires together since I have one less connection to worry about.. This is a little more work to install since you need to remove the wiring tie wraps and then need to weave it back through the mesh wire sleeve. One tip is to start at the mother board end since the Thermistor itself is smooth and slips right through the sleeve. In my case I had previously added a CR Touch and had ran the cables over the cable sleeve. But now since I needed to run a new sensor cable I also put the CR Touch cable into the sleeve. Very clean now. One note is either type of new sensor one needs new Kapton Tape since your need to remove the old stuff to install the sensor.

Extremely high quality thermistors at a great price. Worth keeping as spares at this price.

Exactly as described.

No issues, just follow any random youtube video on how to install a Thermistor and it was cake.

Not quick to install cause of assembly process. Not really hard, just a pain. I accidentally broke a wire on my original for Elegoo Neptune 2S. It was my first printer so I freaked out thinking it was ruined. I was able to use this successfully and get back up and running.

You need these