Authentic Creality Assembled Hotend Kit for Ender 3 / Ender 3 Pro/Ender 3 V2 with Capricorn PTFE and Upgraded Pneumatic Fittings, Thermistor, Heating Element, MK8 Sock and 4 Extra Nozzles

The wire leads are not plug and play. You will need to use electrical tape or some heat shrink to reconnect your old terminals. Plus the filament tubes are way too short (long enough for direct drive I guess). Update. Wired in the hot end and the thermostat on it is busted and reads -14 on my machine. Tested it against another hot end and it reads normal. Final assessment, this was a bad buy. 0 stars if I could rate that.

Works well

Added a new extruder and also got this as well. the nozzle is great if you were thinking about upgrading. I was having bad print quality until I got the extruder and this hot end for my ENDER 3

The hot end is working great so far. It was mostly easy to install plus the included Capricorn feed tube was a great added bonus.

It works and its the same as the original. Worst part about it is this review has a star rating for warmth. Not sure what thats about. Its a hotend not a warmend.

This kit the heater connection comes with 2 ended wires with no connector on it. When you state that your part is a direct replacement, it should come ready to plug in, not in a state where I am going to have to redo the connectors to get them to work. I would not buy this again because of that.

Love the fact it was pre-assembled and love that it came with Capricorn. For me though, the best part about this replacement kit are the 4 couplings that came with it. These couplings are way better than the ones my ender 3 pro came with. I also got two coupling clips, one for the hotend side and one for the extruder side. I will be buying from this seller again, especially with the speedy delivery!

At first I needed a new hot-end to continue my print jobs. Now, I purchased another one to have as a back-up/spare to prevent downtime. Great product, great price & easy to install.

Install is easy polarity of heating element does not matter but I had a lot of temperature variance while printing after install. Found out you can use a software called pronterface to re tune it’s algorithm for heating making it very stable at a temperature of your choosing

My bad -- the product info warned of the voltage difference. The CR is 12 volts, this unit is 24 volts. I had to salvage the 12 volt thermistor and heating cartridge from an old unit to modify this unit.