













BETOOLL A-Frame 2 Brackets Swing Set Bracket with Mounting Hardware (Green)
-
JustMeBeingMe
> 24 hourTitle says everything. They worked perfectly and there has been no issues so far
-
Lynn Lees
> 24 hourThese would have been perfect IF all of the openings were the correct size. We had to cut and sand down 2 of the 4x4s to get them to fit. We measured the bracket openings and 2 of the openings were off by about 1/8. Also the openings for the too beam were slightly off too. We didnt have to cut them but had to sand them and bang on each side about 10 minutes to get them in.
-
Gordon
> 24 hourCant beat these!! Easy to use! This is a no-brainer!
-
Doug Zumbrun
> 24 hourEasy to assemble. Look nice. Grandkids love the swing set I made with them.
-
b lain
> 24 hourOne was a little hard to install. I used a maul hammer and 2by4 to solve my problem. Used 4by6by12 and 4by4by12.
-
RED DOG
> 24 hourAwesome product highly recommend cost around $200.00 for lumber and anchors . Used my old swings of the cheap Walmart swing set and I have a swing set that will last forever . A must have product easy to install .
-
BricksRKids
> 24 hourSuper strong and easy to make your own swing set. Just buy the wood and it’s easy to put together. Very strong.
-
Law O.
> 24 hourThese brackets are great. Make putting up a swing set a breeze. They are serious on lumber size. the 4x6 header should be 3.5x5.5 (mine was not, but a few shallow cuts on 2 faces and a wood chisel got them down to size). My 4x4s (10 length) slid right in. Dont bother with miter cuts, etc... just pop these brackets on and youre good to go.
-
Kenneth R Iverson
> 24 hourVery sturdy and easy to install. My 4x6 top piece wasn’t sized correctly (the brackets were) so I had to sand them a but on the 4” surface but once I got they installing the top piece went well and they 4x4 legs fit perfectly. My wife couldn’t believe that I went from a pile of lumber and brackets to a functioning swing set in an afternoon. It would have been even quicker if Home Depot had sized their 4x6 beams correctly. My granddaughter is thrilled!
-
Derrick Newbill
> 24 hourToo narrow for the boards.. had to do a lot of trimming to get the boards to fit… Was not as easy as sliding in and bolting… Made it work and they’re very sturdy at least….