Creality Ender 3 Glass Bed Upgraded Platform 235x235x4mm for Ender 3 S1/ Ender 3 / Ender 3 Pro/Ender 3 V2/ Ender 5/ Ender 5 Pro, 3D Printer Tempered Glass Build Plate Surface

Best hot bed in my opinion. If you have adhesion problems, use painters tape. just stick it on the area you are printing, let it cool and peel it off.

This is probably the first upgrade I would recommend getting for your ender 3. Filiment Stick alot better than the stock magnetic bed. Quick shipping from the seller as well!

This thing is so nice, they should ship with the printer. It took about 10 minutes to install and I was off and running. The prints stick when its warm and once it cools off the print just comes right off with no fuss. It makes loveling the bed very easy. Pro tip... Adjust the limit switch and put a piece of tape on the glass bed where the printer head travels to autohome. I almost put a big scratch in mine because the nozzle dragged along the top of the bed.

I have tried to find some tips I may be missing on the use of this bed but nothing I have found has been all that helpful. On one side you have the textured surface that seems impossible to properly clean residue from and the other a smooth tempered glass side that while you can use a razor scraper on, will readily crater if you pull the print off in too sharp of an angle. I am using PLA and PLA+, so it may work better with ABS. I just know I am not seeing the reality of the hype for the tempered glass bed at the moment.

Good adhesion if you keep it clean and slow down the initial layer print speed to around 10mm/s. No need for glue. My ender 3 bed is warped, and this bed helps solve that problem by providing a very flat surface that is very even all around. Just make sure to raise the z endstop because this is significantly thicker than the stock plate. Prints come right off when the plate cools!

No matter what i do, nothing sticks to the surface. I do not recommend this product! Get the flexible metal plate instead from annother seller.

The filament won’t stick to the bed no matter what settings I use, what temp I use. Nice bed otherwise but If it cannot keep the filament in one spot, it doesn’t work.

So far I’ve printed three things! This is a definite upgrade from my original Ender build plate! The glass plate is very flat and was easy to level. The adhesion is excellent and after the bed cools the print pops right off.

The clips included withy this Glass Bed cannot be attached without having the print head collide with the clips or the clips colliding with the gantry.

Prints adhere much better to the glass bed - Remember to re-adjust your stopper one upgrading the bed, or else youll destroy your nozzle, and possible the bed!