DC HOUSE 12 Inch 12 High Speed 14mm/s Linear Actuator Motor 1000N DC12V with Mounting Brackets

Used this actuator to control a pivot on a project. First, the actuator is extremely slow operating. Second, it snapped off the rear mounting ear (on the motor housing) on the first use. Its made from extremely cheap cast aluminum and the second it got tweaked, it snapped clean off. Not sure of the actual force limit of this item because the design failed before I could really test the force limits of the unit. Maybe I torqued the actuator across an axis I didnt think I was, but this shouldnt be a failure point given the rating of the actuator.

So far so good great quality

Works okay......pretty slow. Full 12 extending process takes about 34 seconds (less than 9 mm/sec). Full 12 retracting process takes about 34 seconds (less than 9 mm/sec).

It does the important: force said, speed said, long said. BUT it seems to have plastic gears. It sounds like a toy. I dont believe it will last enough. And I dont know if its used or the finish quality is very bad.

Works great, I installed this on a snowblower chute. It worked in -25 below temp, not fast but plenty of power. I would and will buy again for other projects.

Worked as expected. Will use as a door opener/closer on a Chicken Coup.

Some points at data sheet arent accuracy... To extend at maximum length you will have to wait around 30 sec which will be enough for some projects. Depends of you

Used as chute deflector on older model 47 John Deere snowblower. Speed is adequate and have had zero issues.

This unit performs as advertised. It has held up well so far.

Seems like the power just isnt there. I have other actuators that work much better.