









Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)
-
Betsy Tremblay Sr.
> 24 hourWorks like its supposed to!
-
Patrick
> 24 hourReceived an Ender 3 V2 a few months ago and love the bed clips that came with it. Wanted some for my original Ender 3 with an older Creality glass bed and these are perfect! Snug fit with no movement
-
DMBJEM
> 24 hourAlways have these around and are much better than the binder clips that come stock with most printers
-
Devon Ambrose
> 24 hourActually easy to put on and remove unlike other clips, I actually only use 2 cause they work so well
-
Jon V
> 24 hourThey hold the bed securely with only 2 clicks. Id recommend only putting them on the front and back sides of the bed. Not the sides. My printer runs a bead down the left side before every print to prime itself and it hit the click on the side. I moved the clips to the front and back, no more issues
-
Dr. Arden Towne V
> 24 hourNicely made clips but unfortunately the ender 5 table with a glass plate and a PEI sheet is too thick for it. by about 1mm or so.
-
Mickey
> 24 hourI love how strong these things are and I use them on my Ender 3 all the time. Last night I made the mistake of only putting 2 of these things on the back end of my printers bed and the print came out fine. One thing to keep in mind is that if you have an ender 3 you should only put these on the front and back of the bed because the extruder will hit them.
-
XXX
> 24 hourToo wide for an Ender 3 with glass or mirror bed..both stock or sheet mirror. Returned, sadly
-
Dave
> 24 hourScratched glass bed and didnt hold . Waste of money.
-
D
> 24 hourPros: Heavy Duty Red Wheels; Silicon Spacers; Holding great using only M420 S1 for abl. Cons: Was a bit of a pain to level, but doable. These work great so far. Been on a printer that I just built. Took a while to get the bed level, even with using bed leveling visualizer from octoprint; But now it is set and forget. I probes the bed a few times manually after each print for a few prints and it remained the same. Been printing 8+ hours a day for a week with M420 S1 gcode in place of G29 (load mesh vs creating a mesh every run) with 0 problems. Love it.