Tasodin Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(Warm White), Power Adapter not Included
-
Logan Burket
> 3 dayAdhesive sucks, but I didnt expect it to hold anyway I prefer to use hot glue on the edges to hold it down. I put these in a camper that I built as the lighting source and they turned out super cool look at the pictures for the results. Install was just as easy as lights that cost a couple hundred bucks a roll and it cost me $10... Just like many things you get what you pay for but I dont think buying the cheap ones here affected the lights for now Its been one year and they still seem to all be working
-
LouF
> 3 dayAdhesive tape separates from casing. Not sure if anything will, but Im just repressing it for now.
-
Betty S
Greater than one weekGot these to replace non-working lights beneath awning on camper. They fit well, a little narrower than original lights, but fit was good. Plugged into existing wiring, flipped the switch and there was light. I am pleased with this purchase
-
Pamela R Jones
> 3 dayI hated the outdoor light on our RV. I purchased this and we put it on our RV from the light right next to the door and back. It adheres well and has stayed put now for at least 6 weeks. It’s a huge improvement. We can see outside and the stairs well but it’s not annoying. I’d recommend this.
-
Kilher
> 3 dayWorked fine except when applying I. The beginning. Adhesion would come off as you were applying to surface
-
Caimito
> 3 dayDefinitely not Orange, more like Yellow
-
William Reynolds
03-06-2025Distinct lighting under camper
-
V-tech
> 3 dayGreat brightness and seal above LEDs for waterproofing. I am very happy with the outcomes. Installed them in bathtub niche. A bit of soldering and voila! There is latency from when you flip the switch to when they turn on. Maybe my power supply... No big deal. Very happy with them.
-
Don
> 3 dayNice color and easy to use; however, one tiny flaw is that it does not adhere very well at the end where the power cord is attached. The simple remedy (for me) was to put a neodymium magnet over the end... that is, if youre adhering it to a metal surface, like I did.
-
John Hageman
> 3 dayThey didnt stick to clean painted wood
