VIVOSUN Reptile Heating Pad 8x12 Inch with Thermostat Combo Under Tank Terrarium Heating Mat Waterproof for Turtles, Lizards, Frogs, and Other Reptiles

Great!

Havent had it for a year and the adhesive is wearing out and causing the pad to sag and fall off. Should have taken a video or pic to share but it is what it is. Just gonna buy flexwatt and get more, better and more inexpensive. Lesson learned...

Great pad, I have been using it with a thermostat and It has been doing a good job keeping the tank warm.

Size was perfect for a 40 gallon tank.. keeps one side of the tank warm. Perfect for my dragon.

Miltiple times this product reads 0 degrees from the senior and ran the electricity to the heating pad constantly. This ended up creating an unsafe temperature for my reptile (30 degree above my desired temperature).

I wish the heat mat was a little bigger.

I am not super thrilled with this product and I’m worried about the care of my animal because of it. The temperature output is inconsistent and is not reaching the higher temperatures I’m after. I have the thermostat set to 35. The thermostat reading will fluctuate between 32 to 35 throughout the day. What is extra frustrating is that when I check the surface temp of the heat pad with my temp gun, it’s saying only 26-28. I am not confident in the over performance of this product.

I have two of these heat pads. I just purchased a bigger one since I upgraded my tank size. It covered the back half of the tank and goes well alongside the smaller one. The application was smooth and easy with no air bubbles, I just pressed from the center out to make sure the pad stuck well to the glass. These pads do well keeping the temperature controlled and I will definitely be purchasing another soon since the weather has turned colder. Thumbs up all around.

This works fine but be aware of when and how to use it. A lot of times its an unnecessary accessory than can cause more harm than good if not used properly or for the right reasons. Almost all pets are fine at room temperature, 75 degrees or so. Use only when deemed necessary.

The controller sometimes it gets into a weird state where it locks up and reads 0.0 degrees. cycling power is the only way ive fixed it. I dont have enough heater in my take for it to be too big of an issue, but it could easily go bad if you have more heater.