Meconard 6 Pack 4 Inch 5CCT LED Recessed Lighting with Night Light, 2700K/3000K/3500K/4000K/5000K Selectable Ultra-Thin LED Recessed Ceiling Lights, 9W=75W, 750LM, Dimmable Canless Wafer Downlight

We were looking to add some overhead lights to a couple ceiling locations in our house. My wife loves a clean ceiling with very little located in the ceiling that isnt flush and that doesnt blend in so I knew a can light would be our only real option. As this was an existing ceiling, I didnt want to have to do a bunch of ceiling repair work so I looked for an easier solution. These lights fit the bill - you simply drill the hole, run your wire, make the connect to the box, slide the box into the hole and then the spring clips pull the light up flush with the ceiling. We couldnt be happier with these lights installed and the added nightlights are a real bonus.

These lights seem well-made and we have already installed them to replace old lights that did not always work properly. These burn steady and dont get hot. They look great.

These are great lights and easy to install. I did purchase a 6.1 inch circular saw for my drill to make cutting the holes a lot easier. No need for wire nuts because each light has the push connectors already attached with three additional connection holes for each wire. That makes it very simple to connect the lights to each other. Be sure you choose your light setting before placing them in the ceiling or you may have a difficult time getting them back out.

I got these to replace some aging can lights in my living room and kitchen. I wanted LEDs and really liked the fact that these had selectable color temperature. Installation was a snap since I already had existing cans and was about as difficult and time-consuming as changing a light bulb. They fit in perfectly with no gaps around the trim and look like they are dedicated LED cans, not retrofit. A few of the lights are on a dimmer, and my dimmer is compatible with LEDs, so it took no extra effort to get these to work with those lights. It really seems to make a difference in my home. Assuming the LEDs have the projected life span, I dont foresee needing to replace these for a long time.

This are soo easy to install no need to check for studs just cut youre whole and they go right in connection is easy the interchangeable brightness is great and easy love these lights easier than ever. The most convenient lights

The lights dim very smooth and I did not see any flickering. We are going to be installing these in our living room once we get to that point in the renovation so I hope they hold up long term. They were packaged very nicely and the press in wire nuts inside the box seemed to be quality and hold things tight. They also use a standard 3pin low voltage lighting connector if you need to extend the distance to the control box without running more conduit or ROMEX.

Hubby likes these lights, he didn’t have a problem installing them. They’re simple, push in the blue spring clip and pop in the drywall. No trim needed. He also likes that they would be easily removed if needed. They are dimmable, and have different white settings. They come in a handy 12 pack, so we had enough to set up the family room. Very convenient. Would definitely get these again.

I am very pleased with these lights. They look great in my dining room and put off a bunch of light.

very bright, easy to install and dimmable! I could end my review there :-) These are easy to install with push in connectors and work perfectly with the Leviton dimmer I have. Love that you can pick the whiteness that you prefer and they are very bright. The picture I uploaded is at around 50 percent dimmed. I would definitely buy these for any future projects.

These are very nice looking, slim profile “panel” type led lights. They are the flush mount can-less style, with an exposed flat flange ring of less than an 1/8 inch thick. The cutout hole is 6-1/8” diameter, and the trim covers a diameter of approximately 6-5/8. I was replacing an existing 6” led panel light and found that this particular light had a slightly smaller diameter, so if you are doing a retrofit, you may want to check the size of your existing opening against these measurements. Installation is very straight forward. These are meant to be installed in ceilings or walls with enough interior space to fit the included 4” x 2-3/4” x 1-3/8” metal junction/control box and a shorth length of cable; directly wired to a switched light circuit. The provided J-box opens up with a little swing type door which was easy to open by hand, and snaps snugly closed after you make the wiring connections to your light circuit. There are 3 knock-outs which have slots for a screwdriver, but I was able to simply bend and break it off by hand. You will need to provide your own a push-in plastic strain relief to protect the wires coming into the J-box. In the back of the box there are 2 “teardrop” mounting holes for attachment to your ceiling joist if required by your local codes. Each of the internal ground, hot and neutral wires are already attached to their own 4 conductor push-in wire connector, ready to connect to your house wiring. Upon closer inspection, I saw that the existing braided wires were pre-tinned before they were inserted into the connectors at the factory; which I thought was a good indication of the quality of this product. The light panel is cabled to the J-box with a 22 awg PVC coated cable which has an overall length 14”, secured to the light housing with a plastic strain relief clamp, reducing the length to 12”. The quick disconnect plug is located in the middle of the cable, and is keyed internally with a small tab, as well as indicator arrows on the connector to ensure that it is plugged in correctly. It also has a plastic screw-on ring to keep the connector from pulling apart, and it’s easily disassembled for swap-out. The light fixture itself has a nice clean bright white matte finish on the bezel, and the panel face looks to be a textured thick plastic with a slight off-white color. The specs indicate that these consume 12 watts, are dimmable and suitable for damp locations (not direct contact with water, though). Operationally, the light energizes almost instantly with a barely imperceptible delay, and has a slight afterglow which fades quickly when switched off. The light color temperature is switchable from soft white, bright white or daylight (3000/4000/5000K). The color selection slider switch is located on the metal control/junction box, so keep accessibility in mind when installing it. My test installation only involved one led light out of the 12 that I obtained; however, I plan to install 8 more when I complete our kitchen upgrade shortly. I will update my review if I observe any inconsistencies in the operation or quality of the remaining lights in this set, however currently I am very impressed with the quality of this product.