Micro Swiss Bowden Dual Gear Extruder Compatible with Creality Ender, CR10, CR-10 Pro, CR-10S, CR6-SE, Tornado

This extruder installed easily onto my Anycubic Kobra Max. Improved my print quality instantly. Yet another great printer upgrade from Microswiss!

This wonderful product has been the saving grace to hours of troubleshooting, filament skipping and jamming. Best of all its made in the USA. I now know where I will be getting all of my parts from if they have them.

This was a great quick and easy upgrade for the Anycubic Vyper. No issues installing and you dont need the cable that reverses direction. I started off the ESteps at 130 per the instructions, ran some tests and ended up slightly adjusting it. You can find videos on YouTube on how to do this with the Vyper and Octoprint. Installing this and testing/adjusting the ESteps took maybe 30 minutes in total.

Less than 3 days of use, not even running 24/7. Grinding noise coming from extruder. Upon further inspection, the drive gear broke off around the grub screw causing it to skip and ultimately allow the motor to spin freely.

Works as expected. Good quality.

Easy installation

Absolutely everything else about this product is amazing. The build quality is great. The dual extrusion gears are very solid and grip amazingly. But the compression system for holding the tube in place is absolutely trash. It doesnt matter how far I put it on how tight I tighten it it pretty much pops immediately. Complete and total waste of time.

I really like this extruder. While the extruder included with the Ender 6 is all metal, it is not truly dual gear as advertised. The follower gear is more of a spline than a gear. The Micro-Swiss extruder is a true dual gear and has a very positive feed. Installation is very straight forward and it just works. Plus, Made In The USA, always a plus for me. This, added to the Micro-Swiss all metal hotend, has made my Ender 6 a dream to operate. Yes, this extruder is a bit more expensive e than others on Amazon but you won’t regret the extra expense.

Super easy Install, built well and super quite operation good upgrade on my flsun sr

I got this as an upgrade for my CR-6 SE so I can print Carbon Fiber PC as well as getting rid of the plastic extruder that came with the printer. My printer has a filament detector on it, but the install instructions direct you to where you can print out the extension plate to make it fit. Note, only a few models need that printed, not all. Setup was simple, they provided all of the screws and pieces that are needed. Drop in and go. Even eStep calibration is simple. The power and precision that the dual gears provide really do wonders. Prints have became more consistent and the dual gears are strong enough to handle anything. I would recommend this product. If I get a 3rd printer, Ill get another one of these.