E-Z Shim 4 EZ HS400BP Hinge Shim (15 Pack), 15 Count

It did the job! My heavy, solid wood front door was leaning some, causing it to stick pretty tightly above the door handle. I did not want to remove the whole door to fix it because its sooo heavy. There were big gaps on the lower part below the door handle and the upper edge hinge side. I used three layers on the lowest hinge, one shim in the middle hinge. I did have to trim with scissors the plastic to fit the shape of my hinges. Easy peasy. It took about a half hour to adjust and readjust to get it just right to realign my door correctly.

These hinge shims are perfect for nudging your door over a little at a time. I had a slightly crooked exterior door with a gap at the bottom. Just loosened up the screws on my hinges and slid in a shim, tightened up and it did what it was supposed to. Good cheap fix. Recommended! Make sure you know the size and screw pattern of your hinges before buying. :)

Too foamy

Worked great, very easy to install.

did the job

Fixed my door from being unable to lock easily. Great product

These are very useful around the house. Adjusted four doors with these including one with 3 1/2 hinges with a little cutting. The before and after using these makes these doors operate like a very skilled doorman would have installed doors when new. Easy to install.

Installed very easily ans swiftly. My Door had an uneven gap and a slight drop on one side. Put in one at top two in middle and three in bottom hinge. Perfect.

For years I used cardboard for shims with mixed results over time (cardboard compresses over time). I bought these shims when my front door once again wouldnt lock. The dead bolt was hitting below the bore in the door frame. I removed the card board shims and replaced them with two of the EZ-SHIMS. The door locks normally again. I dont see the EZ -Shims compressing like the cardboard does. The only minor issue (really a non-issue for me), is that you will probably have to trim them as they are not the correct shape for most newer hinges. In order to fit the EZ-Shims in the hinge mortise for hinges with rounded corners, two corners need to be trimmed. That is easily done with a pair of scissors.

Didn’t help like I wanted