Creality V4.2.7 Upgrade Mute Silent Mainboard for Ender 3 Customized Silent Board, Ender 3 Silent Mother Board

This board is a must if you don’t have a space away from earshot to run your printer, and even then still worth the money.

It works just fine and was easy to install

Not a drop-in replacement for any printer due to EEPROM is disabled in the firmware. Therefore you loose your setting when you turn off the power.

After exchanging boards, I booted my printer up and....nothing. Ive been trying to flash every firmware known to man, even though it supposedly comes with firmware pre-installed and is supposed to be plug and play, mine was not. Thanks for the waste of time

holy crap my printer is so quiet now and the install was so straight forward and easy. the only part that kind of sucked was remoting the glue the factory uses to secure the connections. my printer work station is in my living room and my wife hated hearing it run before, now it doesnt draw any attention.

I had this thing installed in under a half hour. Just take your time and take pictures of the wire positions. The only wires that dont have letters marked on where they go are the B-MOT & ETEMP on the bottom right, just mark them before removing them. Also make sure you put the ground on the right on them ALL before putting back into the housing.

Bought this, and now my ender is pretty much completely silent. Totally worth it.

This thing is whisper quite, and mounted fairly well. The only issue was the micro SD card slot did not line up with the case and I had to modify the case to get it to allow an SD card to be inserted.

My ender 5 came with the 1.1.5 Melzi board, which is 8 bit.... This was a nice upgrade to be able to install newer Marlin firmware to take advantage of some of the advanced features available.

I didnt even realize the print had started when I first installed it. I dont understand it, but its amazing.