Freud 34-104: 1/8 Radius Rounding Over Bit, EA, Multi

Bought for use in professional production wood shop. Stands up to heavy use. Only now has a few chips in the carbide, but only after many thousands of board feet being run by it! Freud Stand for quality!!

I like it. No dislikes at this time. Sharp and leaves a clean edge

I dont have a lot to say about this bit except that it is working great for me so far. It is sharp and has a nice edge on it. Would buy again.

No issues so far. Cuts clean and true. Good amount of time spent on the current one and its still cutting like a hot knife through butter.

If you want to retain most of the edge of your boards, then give this 1/16 Freud radius roundover bit a try! I like it, but my wife dislikes sharp edges, so Ill likely use it less than the 1/8 roundover bit, which is my go-to. High quality, works great! HIGHLY RECOMMENDED!

Does a good job but it’s not a perfect match for my 3/4” 1/4 round trim. It’s perfect if I replace all my existing trim.

The Freud quadra-cut bits are great. Even with a roundover, run multiple depth passes for best results.

Another great bit. I used it quite extensively (for two profiled 3 in 1 high chairs). It is just perfect bit for the job.

Cuts smooth and clean. Vast improvement over the cheapies I had been using

I purchased a DeWalt DW618 router and this bit to round over the stair treads and guardrail tops on my pressure-treated pine deck. This bit is amazing. It EATS pine. Super-smooth result on the side grain, and fairly smooth on the end grain.